Ceramic industrial coating AquaSeal WX-8887

Product families

Other characteristics

Features

Fast Drying, Good Blocking Resistance, Good Sanding Properties, High Clarity, High Solids Content; High solids, good build; Good sanding; Fast dry to sand and packing; Excellent Clarity; Very fast development of block resistance; Ready to spray, no reduction needed; Versatile application – may be applied conventional, airless, air-assisted airless, or HVLP

Show in full

Product Type

Sealer, Solventless & High Solids Coating, Waterborne Coating; Sealer; Solventless & High Solids Coating; Waterborne Coating

Application Method

Spray

Compatible Substrates & Surfaces

Wood

Note

*Values calculated from formula

Markets

Paints & Coatings

Shelf LIfe

24 Months (60-77°F)

Technology

Ready-to-Use Products

Benefits

The benefits of water-based clear coatings:; On-trend, achieve desired looks; Safe, non-toxic and environmentally-friendly; GREENGUARD certifications; Non-flammable; Durability equivalent to traditional solvent products; Excellent color stability and clarity; Application-friendly and ideal processing times

Application Methods

Spray

Application Procedure

Mixing; Mix Pails or Drums thoroughly before use to ensure uniform consistency; Reducer; Deionized or distilled water for general viscosity reduction; Use IM-078 Aqua Retarder to reduce viscosity and slow dry time; Application; Spray application conventional equipment, airless, air assisted or HVLP equipment.; Apply approximately 3-4 wet mils for 1-2 mil dry film thickness.; Surface Preparation; Wood must be clean, dry and finish sanded. Substrates should be free of grease, oil, dirt, fingerprints and any contamination to ensure optimum adhesion and coating performance properties.; Moisture content of wood should be 6 to 8 %.; Sand first coat in order to eliminate grain raising and to improve the adhesion of the subsequent coat.; 150 grit on open grain and 180 grit on closed grain wood.; Always sand the sealer-coat within 8 hours prior to top-coating to improve adhesion.; Use Directions; For Interior use only. Dry 16 hours prior to stacking. Quicker stacking times may be achievable, though performance must be evaluated by the user. Stack only when the surface temperature is below 95°F. During periods of very low humidity (usually winter) keep temperatures in the spray booth and drying areas low (65°F – 70°F) and reduce air movement to reduce the tendency to haze.; Drying Time; 11 – 17 minutes dry to touch; 25 – 30 minutes dry to sand; 2 – 4 hours dry to pack; Clean Up; Soap and water for general clean up.; Recommended Topcoat; Ceramic product lines tested and approved as topcoats are : AquaLac Series of products.; Recommended Stain; WX-8746 AquaChrom Stain Base, AquaChrom intermix stain blending system.

Show in full

Ready to Use Product Features

• Fast Drying
• Good Blocking Resistance
• Good Sanding Properties
• High Clarity
• High Solids Content

Compatible Substrates and Surfaces

Wood