Ceramic industrial coating AquaLac Plus WX-8896XX

Product families

Other characteristics

Features

Excellent Transparency Properties, Fast Drying, Good Blocking Resistance, Good Feel, Good Sanding Properties, Good Surface Finish, High Clarity, High Solids Content, Self-sealing; Excellent finish quality, hand feel and transparency; Higher solids, faster build; Excellent sanding; Fast dry to sand & packing; good block resistance; Ready to spray, no reduction needed

Show in full

Product Type

Solventless & High Solids Coating, Waterborne Coating; Solventless & High Solids Coating; Waterborne Coating

Application Method

Spray

Compatible Substrates & Surfaces

Wood

Note

*Values calculated from formula

Markets

Paints & Coatings

Shelf LIfe

12 Months (60-77°F)

Technology

Ready-to-Use Products

Benefits

The benefits of water-based clear coatings:; On-trend, achieve desired looks; Safe, non-toxic and environmentally-friendly; GREENGUARD certifications; Non-flammable; Durability equivalent to traditional solvent products; Excellent color stability and clarity; Application-friendly and ideal processing times

Application Methods

Spray

Application Procedure

Mixing; Mix to ensure uniform consistency, but do not over-mix. Mix well 10 minutes twice daily. Reducer; If needed DI or distilled water; use IM-078 Aqua Retarder to slow drying and reduce haze; use IM080 Frosting Eliminator to reduce haze that cannot be eliminated by Aqua Retarder. Application; Spray using conventional equipment, airless, air-assisted or HVLP equipment.; Apply approximately 3-4 wet mils for 0.8 – 1.1 mil dry film thickness per coat.; Surface Preparation: Wood must be clean, dry and finish sanded. Substrates should be free of grease, oil, dirt, fingerprints and any contamination to ensure optimum adhesion and coating performance properties. Moisture content of wood should be 6 to 8 %.; Sand first coat in order to eliminate grain raising and to improve the adhesion of the subsequent coat. 150 grit on open grain and 180 grit on closed grain wood. Always sand the sealer-coat within 8 hours prior to top-coating to improve adhesion.; Use Directions; For interior use only. Dry a minimum of 4 hours under ideal (warm, dry) conditions prior to stacking.; Quicker stacking times may be achievable, though performance must be evaluated by the user.; Stack only when the surface temperature is below 90°F. During periods of very low humidity (usually winter) keep temperatures in the spray booth and drying areas low (65°F – 70°F) and reduce air movement to reduce the tendency to haze.; Drying Times; 30 minutes dry to sand; 4 – 6 hours dry to stack; 5 minutes dry to sand; Tinting: To mimic aged lacquer over natural maple tint with 0.05% (wt) CW-5605. Clean Up: Water, SS-213 Isopropanol Recommended Sealer: Self-seal or WX-8887 AquaSeal Recommended Stain: WX-8746 AquaChrom Stain Base

Show in full

Ready to Use Product Features

• Excellent Transparency Properties
• Fast Drying
• Good Blocking Resistance
• Good Feel
• Good Sanding Properties
• Good Surface Finish
• High Clarity
• High Solids Content
• 1 more

Compatible Substrates and Surfaces

Wood