Permatec 4000

Product families

Other characteristics

Brand

Permatec

Features

Chemical Resistant, Fast Cure, Skid Resistant, Wear Resistant; PERMATEC 4000 is a 100% solids system and allows for a fast application where excellent chemical and wear resistance are required.; PERMATEC 4000 can be installed over most sound floors including old or new concrete and most types of repair mortars.; At varying thicknesses up to 1/4 inches, thePERMATEC 4000 system provides long term chemical resistance for splash and spill, or immersion service in many chemicals.; PERMATEC 4000 is similar to PERMATEC 3000 but gives a higher degree of chemical resistance to concentrated acids, caustics and solvents.; As with all PERMATEC systems, PERMATEC 4000 provides excellent physical protection even in the harshest industrial settings.; Rapid cure resulting in minimal downtime.; 100% non-porous; Odor free; Non-skid safety finish.; Can be applied over damp concrete.

Show in full

Product Type

2K (2 component) Coating, Solventless & High Solids Coating; 2K (2 component) Coating; Solventless & High Solids Coating

Application Method

Trowel

Mixing

Prior to application, the PERMATEC 4000 (Resin, Hardener and Silica) and the substrate should be between 65°F and 90°F.; In order to maintain a clean mixer from batch to batch, the Resin (Part A) and a portion of the Silica (Part C) should be added to the mixer and agitated long enough to clean the blades.; Add the Hardener (Part B) only when the batch is ready to be applied.; Mix for approximately 30 seconds - 1 minute, then add the remainder of the Silica and mix for another 90 seconds.; Pour immediately onto the floor.

Show in full

Safety

PERMATEC 4000 contains blended epoxies as the resin and blended amines as the hardener. Protective clothing and gloves are recommended to prevent sensitization to these materials. In case of ingestion or eye contact, it is advisable to contact a physician immediately.

Markets

Building & Construction

Clean Up

All mixing and application equipment should be cleaned immediately after use. If this is done, soap and water or biodegradable cleaners can be used. If the material has begun to set, more aggressive solvents will be necessary.

Function

The primary use of PERMATEC 4000 is as a high strength floor topping for industrial service where severe mechanical abuse and/or chemical exposure is anticipated.

PACKAGING

PERMATEC 4000 is available in 20, 100, and 1000 square foot units based on 1/4 inch applications. Each unit consists of pre-measured components, Part A (Resin) and Part B (Hardener). Graded aggregates are available or may be sourced locally.

Technology

Ready-to-Use Products

Labeling Claims

Odor-free

Application Methods

Trowel