Permacoat 3000 CT

Product families

Other characteristics

Brand

Permacoat

Features

Chemical Resistant, Cost Effective, Low Odor, Low Temperature Performance, Rapid Cure Response, Skid Resistant; PERMACOAT 3000 CT allows for fast, easy applications at tem-peratures as low as 45°F.; In addition, the system provides chemical resistance and physical performance much higher than those found in paints and many other thin mil coatings.; Rapid cure, resulting in minimal downtime.; Very low odor; Non-skid safety finish

Show in full

Product Type

2K (2 component) Coating, Epoxy Coating, Solventless & High Solids Coating; 2K (2 component) Coating; Epoxy Coating; Solventless & High Solids Coating

Application Method

Roller, Wipe

Compatible Substrates & Surfaces

Concrete, Metal, Steel, Wood

Safety

PERMATEC 3000 CT contains blended epoxies as the resin and blended Amines as the hardener. Protective clothing and gloves are recommended to prevent sensitization to these materials. In case of ingestion or eye contact, it is advisable to contact a physician immediately.

Markets

Building & Construction

Clean Up

All mixing and application equipment should be cleaned immediately after use. If this is done, soap and water, or bio-degradable cleaners can be used. If the material has begun to set, more aggressive solvents will be necessary.

Function

The PERMACOAT 3000 CT system is designed as a medium duty (30- 90 mils) floor coating and/or secondary containment system where moderate mechanical abuse and chemical exposures are anticipated. PERMACOAT 3000 CT can be installed over most sound substrates including old or new concrete, steel and wood. PERMACOAT 3000 CT provides a cost effective alternative to high build floor toppings.

Show in full

PACKAGING

The PERMACOAT 3000 CT system is packaged in one and three gallon units. Each unit consists of pre measured components, Part A (Resin) and Part B (Hardener).

Maintenance

For systems designed for splash and spill exposures, routine wash downs are recommended to reduce the length of chemical exposure. This step is not necessary where the product is recommended for containment service.

Technology

Ready-to-Use Products

Application Methods

• Roller
• Wipe

Application

PERMA COAT 3000 CT application is as follows:; Use a rubber squeegee to spread the resin over the pre-measured area to be covered.; Immediately back roll the PERMA COAT 3000 CT with a short nap (1/8 inches) wool or mohair roller.; After the coating has been back rolled and uniform thickness verified, the surface should be saturated with a silica broadcast.; After the first coat supports foot traffic, the excess silica can be removed and the remaining steps completed.; PERMACOAT 3000 CT should not be applied over substrates:; Which are wet during the application.; Subject to extreme hydrostatic pressure.; Unsound structures.; Contaminated substrates which cannot be cleaned.; At temperatures below 45°F.

Show in full

Shelf Life Storage

PERMACOAT 3000 CT should be stored at 50 - 70°F out of direct sunlight. All containers should remain unopened until ready for use. If stored as set out above, this product has a minimum shelf life of one year.

Cure Time and Coating Thickness

The cure time of PERMACOAT 3000 CT and other resinous systems are very dependent upon the temperature of the substrate. The chart below represents the approximate times for the respective service conditions, following the last coat:

Ready to Use Product Features

• Chemical Resistant
• Cost Effective
• Low Odor
• Low Temperature Performance
• Rapid Cure Response
• Skid Resistant

Compatible Substrates and Surfaces

• Concrete
• Metal
• Steel
• Wood