Flextille 100 Flex Epoxy Mortar
- Chemical Family
- Epoxy & Epoxy Derivatives
100 Flex Epoxy Mortar is used for setting most types of ceramic floor tile, porcelain tile, quarry tile, and resistant floor bricks and pavers where chemical resistance and high strength and impact resistance is required. For setting green marble, agglomerates, or other natural stones that are susceptible to warping and distortion when set with conventional Portland cement mortars
Product families
- Ceiling Tiles
- Other Flooring & Surface Applications
Other characteristics
- Features
Bondability, Easy To Finish, Good Compressive Strength, High Solids Content, Water-based; Superior bond and compressive strengths; Easy to mix and apply; Withstands steam cleaning; Ultra strong; Easy cold water clean-up; Will not distort green marble or similar unstable natural stones
- Product Type
- Mortar
- Application Area
- Masonry
- Caution
Avoid skin contact. Wear rubber gloves and protective clothing. Wash hands frequently with soap and water and before breaks or eating. Remove and wash contaminated clothing. Keep out of reach of children.
- Markets
- Building & Construction
- Shelf LIfe
- 1 Year
- Limitations
Use only on surfaces maintained at a temperature of 15°C (60°F) to 35°C (95°F) during application and while curing. Do not use in areas subject to excessive heat. Cured 100 Flex Epoxy Mortar will resist temperatures up to 100°C (212°F). For exterior applications, consult Flextile Technical Service. Not recommended for use over particleboard, chipboard, asbestos cement board, or similar unstable materials.
- Maintenance
No maintenance is required except where damages result from unforeseen circumstances
- Availability
Flex-Epoxy 100 - 100% Solids Epoxy Mortar is available from Flextile Ltd. and its distributors in 7.6 liter (2 US gallon) containers. Each container consists of: Part A epoxy resin / aggregate mixture, Part B hardener, and a separate portion of graded silica sand for use on heavier applications.
- Technology
- Ready-to-Use Products
- Packaging Type
- Pails
- Technical data
- Exceeds ANSI A118.3 requirements
Technical data
Table 1 of 1
13 rows| Characteristic | Value | Unit |
|---|---|---|
| Approx. Coverage (7.6 Liter, 6 mm (1/4") notched trowel) | 3.4 | m² |
| Approx. Coverage (Per7.6 Liter, 5 mm (3/16") notched trowel) | 7.4 | m² |
| Cleanability | With water before material dries | — |
| Compressive Strength | 60.0 | Mpa |
| Final Cure | 7.0 | Days |
| Hardness (24hr.) | 85.0 | Shore D |
| Initial Cure | 24.0 | Hours |
| Linear Shrinkage | 0.0 | % |
| Pot Life | 1 - 1.5 | Hours |
| Specific Gravity | 1.4 | — |
| Tensile Strength | 8.4 | Mpa |
| Thermal Shock | 3.9 | Mpa |
