MiraGard HD50

Other characteristics

Brand

MiraGard

Features

Abrasion Resistant, Durable, Fast Drying, Good Adhesion, Good Non-Yellowing Properties, Good Weather Stability, High Gloss, High Hardness, UV Resistant, Wear Resistant

Product Type

1K (1 component) Coating, Sealer, Solventborne Coating; 1K (1 component) Coating; Sealer; Solventborne Coating

Compatible Substrates & Surfaces

Brick, Concrete

Usage

• Natural and pigmented concrete surfaces.
• Exposed aggregate concrete.
• Stamped full depth concrete and overlays.
• Natural and cast stone, slate and flagstone.
• Colored and natural gray concrete pavers.
• Brick and other masonry surfaces.
• Unglazed tile and stucco.

Markets

• Building & Construction
• Paints & Coatings

Mix Ratio

Single component, pre-mix prior to use.

Advantages

Long wearing, durable, abrasion resistant.; Excellent hot tire resistance.; Excellent adhesion.; Fast drying and recoat time.; Excellent UV resistance and weathering characteristics.; Non-yellowing formulation; Chemical resistant.; High Gloss.; VOC-compliant.

Limitations

Apply only when temperatures are a minimum of 50°F (10°C) and a maximum of 90°F (32.2°C), and surface is thoroughly dry.; Do not apply if rain is anticipated within 24 hours, or if ambient temperature is within 5°F of dew point.; Due to solvent content, must be applied over compatible substrates only.; Not for use in residential garage floors within SCAQMD air quality jurisdiction only. Acceptable for use in residential g; Not recommended over many acrylic thin film paints, sealers or coatings – Application can be accomplished following special manufacturer's instructions when application is over Miracote coatings, stains or sealers.; Keep away from ignition sources.; Sealed surfaces may be slippery when wet. Consider the incorporation of a slip-resistant medium.

Show in full

Technology

Ready-to-Use Products

Packaging Type

Pails

For Best Results

Always install a minimum 4' by 4' test area or job site mock-up for owner approval of acceptable color, texture, finish, adhesion, and any other critical requirement prior to proceeding. Protect materials at all times from excessive heat and cold, and pre-condition to room temperature as necessary.; Regularly check wet film thickness with mil gage, and monitor consumption to ensure correct application rates are obtained.; The proper application of this product is the sole responsibility of the end user. Job site visits by Miracote representatives are only for the purpose of making recommendations. Supervision and quality control are the sole responsibility of the user.; It is recommended to apply in two coats at the published coverage rates. Do not apply in one thick coat.; Measure substrate temperatures to ensure that material is applied when temperatures are between 50°F (4.5°C) and 90°F (32.2°C) during placement.; Verify all ventilation ducts are sealed shut or blocked to prevent diffusion of solvent fumes.; During application in direct sunlight and elevated temperature conditions thinning MiraGard HD 50 with acetone at a rate not to exceed 25% is acceptable to improve absorption, increase working time, and minimize bubbling and streaking.

Show in full