Crafco HOT-APPLIED BITUMINOUS MARKER ADHESIVE
- Chemical Family
- Bituminous Coal
Crafco Hot-Applied Bituminous Marker Adhesive is a hot-applied adhesive which, when properly applied, bonds markers and reflectors to both asphalt and concrete pavement surfaces. The adhesive is supplied as an easy to use single component material which is easily melted and poured or pumped onto pavement surfaces. Since it is a hot melt composition, the adhesive sets up on cooling and is ready for traffic in less than 5 minutes. Heating can be performed in either directly or indirectly heated melting units. The adhesive contains no rubber polymers which can degrade at application temperature. Hot-Applied Bituminous Marker Adhesive has been a quality Crafco product for over 20 years.
Product families
Applications
- Coatings & Markings
Product Families
- Hot Melt Adhesives
Other characteristics
- Product Type
- 1K (1 component) Adhesive, Hot Melt Adhesive
- 1K (1 component) Adhesive
- Hot Melt Adhesive
- Compatible Substrates & Surfaces
- Asphalt, Concrete
- Markets
- Building & Construction
- PACKAGING
Hot-Applied Bituminous Marker Adhesive is supplied in self-release 3 compartment disposable boxes which contain approximately 50 lbs. (22.7 kg) of material. The boxes are palletized into shipping units weighing approximately 2400 lbs. (1089 kg). Material is sold by the net pallet weight.
- Shelf LIfe
- Minimum 2 Years
- Installation
The specific gravity of the adhesive is 1.8 at 77°F (25°C). Prior to use, the user must read and follow Installation Instructions for Hot-Applied Pavement Marker Adhesives to verify proper product selection, heating methods, pavement preparation procedures, application geometry, usage precautions and safety procedures. These instructions are provided with each pallet of adhesive.
- Technology
- Ready-to-Use Products
- Packaging Type
- Boxes
- Labeling Claims
- VOC-free
- Specification Conformance
Hot-Applied Bituminous Marker Adhesive meets requirements for bituminous adhesive for pavement markers specified in ASTM D4280 and D4383. After melting, using gentle heating supplied by a hot plate or flame and stirring while heating to 400°F (204°C) the adhesive meets the following requirements
- Compatible Substrates and Surfaces
- Asphalt
- Concrete
Technical data
Table 1 of 1
14 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Filler Content by Weight | 65 - 75 | % | — |
| Filler Fineness No. 200 Sieve | min. 95 | % | — |
| Filler Fineness No. 325 Sieve | min. 75 | % | — |
| Filler Fineness No. 100 Sieve | min. 100 | % | — |
| Flash Point | min. 288 | °C | ASTM D92 |
| Flow (158°F) | 5.1 | mm | ASTM D5329 |
| Heat Stability Flow | 5.1 | mm | — |
| Penetration (77°F) | 10 - 18 | — | ASTM D5 |
| Penetration (140°F) | 45 - 65 | — | ASTM D5 |
| Recommended Pour Temperature | 375 - 425 | °F | — |
| Softening Point | 200 - 264 | °F | ASTM D36 |
| Thermosel Viscosity (400°F) | 3 - 7.5 | Pa·s | ASTM D4402 |
