ReVue™ SLM
ReVue™ SLM is a self-leveling underlayment based on Portland and Aluminate cement that is fortified with latex polymer and can be used to level or smooth most properly prepared substrates. Extended working time (30 minutes) allows for a more consistent finish by eliminating seams or cold joints that may occur when using products with a shorter working time. It leaves a finished surface that is suitable for most floor covering systems and can withstand temporary construction traffic.
Product families
Applications
- Fillers Levellers & Joints
Product Families
- Mortar & Grouts
Other characteristics
- Brand
- ReVue
- Features
Cost Effective, Excellent Flowability, Excellent Leveling Properties, Self Healing
- Product Type
- Mortar
- Application Area
- Ceramic Tiles, Masonry
- Ceramic Tiles
- Masonry
- Application Method
- Roller
- Usage
Ideal for use in the following applications: Excels at leveling large areas. Surfaces such as concrete, well-bonded abraded mortars and ceramic tiles can be prepared for the installation of carpet, resilient floors, wood parquet, slate, ceramic tile, marble, granite or stone veneer floors. Properly prepared exterior grade plywood, cement board, anti-fracture membranes, insulating panels and other approved board underlayments may be covered.
- Markets
- Building & Construction
- Storage
Materials should be stored indoors between 50ºF (10ºC) and 85ºF (29ºC). Do not allow ReVue-SLM to freeze.
- Disposal
Dispose of all excess material, packaging and other waste in accordance with federal, state and local regulations.
- Advantages
Long working time—flowable for approximately 30 minutes; Pours up to 1-1/2" thick; Excellent healing properties—self healing; Depth may be extended with aggregate; Withstands construction/renovation traffic; An economical solution to a smooth level floor; Aluminate cement promotes better flowability; No VOC (0 g/L).
- Shelf LIfe
- One year from date of manufacture.
- Limitations
Do Not Use: 1. Where either the surface or air temperature falls below 50°F (10°C) or above 85°F (29°C) within 72 hours after installation. 2. When finished floor is subject to freeze (32°F or 0°C) any time within 7 days. 3. Where hydrostatic pressure is present or moisture emissions exceeds level permitted for an installed floor covering. 4. Over particle board, presswood, masonite, chipboard, Luaun, or similar dimensionally unstable materials or any substrate not well bonded or free of movement. 5. Over metal or other gypsum floor patches and materials, petroleum or solvent residue or spills, or other contaminants.
- Technology
- Ready-to-Use Products
- Packaging Type
- Bags
- Labeling Claims
- VOC-free
Technical data
Table 1 of 1
7 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Compressive Strength (28 days) | 5000 (34.47) | psi/MPa | ASTM-C109 |
| Flexural Strength (28 days) | 1200 (8.27) | psi/MPa | ASTM C78 |
| Hard Dry Time (Minimum Thickness at 70°F (21°C) | 8 - 24 | hours | — |
| Set Time (Increase to Yellow Units (CIE Δb) | 1 - 2 | hours | — |
| Tensile Strength | 420 (2.89) | psi/MPa | — |
| Volatile Organic Compound (VOC) | 0 (0.0) | g/L/lb/gal | ASTM D2369-81 |
| Working Time | approx. 30 | minutes | — |
