AQUAFIN® InjectProECO-SEAL

Product families

Other characteristics

Brand

AQUAFIN

Features

Flexible, Good Bonding Strength, High Tensile Strength, Hydrophilic, Low Viscosity, Non-Toxic

Product Type

Solventless & High Solids Coating

Note

Proper application is the responsibility of the user. Field visits by AQUAFIN personnel are for the purpose of making technical recommendations and not for supervising or providing quality control on-site.

Safety

Refer to SDS. For commercial use only. Avoid contact with skin and eyes. Wear rubber gloves and safety goggles during mixing and application. After contact with skin, wash with plenty of water. In case of eye contact, rinse immediately with plenty of water for 15 minutes and seek medical advice. KEEP OUT OF REACH OF CHILDREN. LIMITED WARRANTY: AQUAFIN, INC. warrants this product for a period of one year from the date of installation to be manufactured free of defects and to be consistent with its technical properties as stated in our current Technical Data Sheet. This product must be used as directed and within its stated shelf life. AQUAFIN INC. will replace or at our discretion refund the purchase price of any product, excluding cost of labor, which is proven to be defective. Our product recommendations are based on industry standards and testing procedures. It is the buyer's obligation to test the suitability of the product for an intended use prior to using it. We assume no warranties written, expressed or implied as to any specific methods of application or use of the product. AQUAFIN INC. MAKES NO WARRANTY AS TO MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE AND THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED. AQUAFIN, INC. shall not be liable for damages of any sort including remote or consequential damages, down time, or delay. Any claim for a defective product must be filed within 30 days of discovery of a problem, and must be submitted with written proof of purchase.

Show in full

Markets

Building & Construction

PACKAGING

InjectProECO-SEAL Resin: 5 gallon pails and 50 gallon drums

Advantages

• Zero VOC's - meets LEED criteria • 100% solids, non-flammable, non-toxic permanent seal • Does not contain TDI or solvent • Hydrophilic - seeks water in cracks • Pumped as a single component • Can expand more than 25 times initial volume • Excellent adhesion, resistance and durability • Non-hazardous shipping

Limitations

Temperature significantly affects viscosity. Protect material from excessive heating and cooling prior to grouting to avoid affecting viscosity. • If using water baths to cool or heat pails avoid splashes to prevent water coming in direct contact with resin - this will activate the reaction. Do not warm above 90°F. • Do not reseal containers of contaminated materials as it can create pressure. • Clean up spills with adequate ventilation and appropriate personal protective equipment. Cover the spill area with absorbent material such as clay or vermiculite and transfer to metal waste containers. Wash area with decontamination solution (5-10% solution of sodium carbonate). Dispose of waste in accordance with federal, state and local regulations.

Show in full

Technology

Ready-to-Use Products

Reaction Time

When mixed with water at a 1:1 ratio the typical initial reaction time is 20 seconds, with final reaction at approx. 3 minutes.

Labeling Claims

• Environmentally Friendly
• Non-Flammable
• VOC-free

Shelf Life Storage

Shelf life is two years when stored properly. Product is highly moisture sensitive. Store in original sealed containers at temperature between 40°F – 90°F. Opened containers must be handled properly to prevent moisture contamination.