Ebalta Kunststoff Gmbh AH 120TGS
- Chemical Family
- Epoxy & Epoxy Derivatives
Ebalta AH 120 / TGS is heat resistant laminating resin.
Product families
Applications
- Exterior & Body
- Interior
- Other Automotive Applications
- Textile Manufacturing
- Aerospace & Aviation
Product Families
- Epoxies
Other characteristics
- End Uses
Aircraft Applications, Aircraft Interiors, Automotive Applications, Automotive Exterior Parts, Automotive Interior Parts, Textile Applications
- Polymer Name
- Epoxy Resins & Compounds
- Processing Methods
- Laminating
- Markets
- Automotive & Transportation
- Industrial
- Storing
At appropriate storage 18-25°C.; Occuring crystallization due to disadvantageous storage conditions can be made return by warming up the material at approx. 60° C for some hours.; Opened containers should be closed immediately after use and be protected against moisture. This material should be used up as soon as possible.; Shelf life is indicated on the labels
- Properties
- unfilled low viscosity high strength fast curing
- Cure
- Chemical Cure
- Technology
- Plastics
- Material Features
- Fast Curing
- High Strength
- Low Viscosity
- Very Good Heat Resistance
- Processing Instruction
The temperature of material and processing should be between 18 and 25° C.; The mixing of resin and hardener should be made intensively and if possible without any bubbles at room temperature.; We recommend a post curing with a temperature rise of about 10°C/hour. Difficult geometries should be supported during the curing cycle. Afterwards the part should be cooled down at about 20°C/hour.
- Plastics and Elastomers End Uses
- Aircraft Applications
- Aircraft Interiors
- Automotive Applications
- Automotive Exterior Parts
- Automotive Interior Parts
- Textile Applications
- Plastics and Elastomers Functions
- Resin
- Plastics and Elastomers Processing Methods
- Laminating
Technical data
Table 1 of 1
12 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Shore hardness | 86 ± 2 | Shore D | DIN ISO 7619-1 |
| Viscosity (25°C) | 700 ± 100 | mPa.s | — |
| Coefficient of thermal expansion | 10-6K-1 | 10-6K-1 | — |
| Density (20°C) | 1,12 ± 0,02 | g/cm3 | — |
| Compressive Strength | 100 ± 10 | MPa | EN ISO 604 |
| Pot Life (200g/20°C) | 20 - 25 | minutes | — |
| Flexural elongation at break | 7.3 ± 0.2 | % | EN ISO 178 |
| Curing time at RT | 6-8 | Hrs | — |
| Flexural modulus | MPa | MPa | EN ISO 178 |
| Post Curing | 6 - 8 ( 50 - 60) | Time in h (Temperature in °C) | — |
| Post Curing | 3 - 5 ( 80 - 90) | Time in h (Temperature in °C) | — |
| Heat resistance (HDT) | °C | °C | — |
