Creative Materials Inc. 122-01(UT)
122-01UT is a single component ink and adhesive suitable for application by screen printing or syringe dispensing. This product features a unique high continuous operation temperature and very high glass transition temperature making it especially well-suited for extreme conditions found in furnace, heater, and aerospace applications. 122-01UT is a version of 122-01(P) with improved adhesion to a wide range of substrates and features improved flexibility over typical high temperature materials.\nFeatures\nHigh service temperature polyimide dielectric.
Product families
Applications
- Aerospace & Aviation
Product Families
- Structural Adhesives
Other characteristics
- Product Type
- 1K (1 component) Adhesive
- Application Area
- Aerospace Applications, Furnace, Heaters
- Aerospace Applications
- Furnace
- Heaters
- Application Method
- Injection, Screen Coating
- Markets
- Automotive & Transportation
- Storage
Shelf life up to 1 month at 25°C; or 3 months at 5°C; or 6 months at -10°C; or 12 months at -40°C. For extended storage -40°C is recommended. For syringe storage see syringe handling guidelines for recommendations on storage and maintaining homogeneity of material over long-term storage.
- Shelf LIfe
1 month at 25°C, 12 months at -40°C, 3 months at 5°C, 6 months at -10°C
- Technology
- Ready-to-Use Products
- Safety and Handling
Use with adequate ventilation.; Keep away from sparks and open flames.; Avoid prolonged contact with skin and breathing of vapors.; Wash with soap and water to remove from skin.
- Application Methods
- Injection
- Screen Coating
- Curing and Bonding
To use as an adhesive, apply b-staged adhesive to one part, carefully align parts to be bonded, apply uniform pressure to maintain location. Cure 60 minutes at 150°C followed by either 60 minutes at 250°C or 2 hours at 200°C. For better adhesion of the b-staged film to the first part, it is suggested to warm the part to 80°C. Cure times given are mass related, timing should start after adhesive and substrates reach curing temperature. For maximum chemical resistance a final cure temperature of 180°C is required. End user is advised to experimentally determine temperature and time best suited for individual applications.
- Suggested Handling
122-01UT is ready to use as supplied but can be thinned down with CMI 102-03 for printing optimization.
- Certifications and Compliance
- ISO 14001
- ISO 9001
- Ready to Use Product Features
- Excellent Flexibility
- Excellent Substrate Adhesion
- High Temperature Performance
Technical data
Table 1 of 1
8 rows| Characteristic | Value | Unit |
|---|---|---|
| Viscosity | 25,000 - 30,000 | cps |
| Volume Resistivity | min. 1x 10^15 | Ω - cm |
| Dielectric Constant | 4 | — |
| Dielectric Strength | min. 4,000 | volts/mil |
| Glass Transition Temperature | min. 320 | °C |
| Hydrolytic Stability | Excellent | — |
| Useful Temperature Range | -55 to 330 | ºC |
| Thermal Stability | Good to +410 | °C |
