Creative Materials 112-05
112-05 is screen-printable, anisotropic, conductive hot melt adhesive. This product features excellent adhesion to Kapton, Mylar, glass and a variety of other substrates. Unlike conventional conductive materials, this product is very resistant to flexing and creasing. The product can be rebonded many times by simply adding heat and slight pressure. Applications for 112-05 include, but are not limited to, conductive splicing of ribbon cables, PTF circuits, and electrical attachment of surface mounted devices. This product is useful in application where shorts between closely spaced contacts is a concern. 112-05 is a screen-printable version of 111-29.\nFeatures
Properties
- Physical Form
- Paste
Identification
Product families
- Conductive Adhesives
Other characteristics
- Cure Method
- Heat Cure
- Product Type
- Conductive Adhesive, Hot Melt Adhesive
- Conductive Adhesive
- Hot Melt Adhesive
- Application Area
- Electrical Components, Ribbon Cables
- Electrical Components
- Ribbon Cables
- Application Method
- Screen Coating
- Compatible Substrates & Surfaces
- Glass, Plastics, Polyimide
- Shelf Life
2 months at 25°C, 6 months at 5°C, 9 months at -10°C
- Cure
- Heat Cure
- Technology
- Ready-to-Use Products
- Curing
112-05 is ready to use as supplied. Further thinning may be accomplished by adding small amounts of CMI Thinner # 113-12. Apply thin film of adhesive to one or both surfaces to be bonded. Apply adhesive to a total dry thickness of 0.6 - 1.3 mils. Dry at room temperature for approximately 30 to 40 minutes, or 1-3 minutes at 120°C. Place the two surfaces together and cure in a heat-sealing press for 5-7 seconds @ 175°C using 100 - 150 psi to hold the surfaces tightly together. End user is advised to experimentally determine pressure, temperature and time best suited for individual applications. (See back of sheet for step-by-step directions.)
- Safety and Handling
Use with adequate ventilation.; Keep away from sparks and open flames.; Avoid prolonged contact with skin and breathing of vapors.; Wash with soap and water to remove from skin.
- Application Methods
- Screen Coating
- Certifications and Compliance
- ISO 9001
- Ready to Use Product Features
- Anisotropic
- Creasing Resistance
- Flexing Resistance
- Compatible Substrates and Surfaces
- Glass
- Plastics
- Polyimide
Technical data
Table 1 of 2
1 row| Characteristic | Value | Unit |
|---|---|---|
| Minimum Cure Temperature | 80 | °C |
Table 2 of 2
5 rows| Characteristic | Value | Unit |
|---|---|---|
| Volume Resistivity (X and Y Axis) | 1x 10^12 | Ω - cm |
| Volume Resistivity (Z Axis) | 0.0001 | Ω - cm |
| Hydrolytic Stability | Excellent | — |
| Useful Temperature Range | -55 to 140 | ºC |
| Peel Strength | 9 - 11 | lbs./inch |
