Creative Materials 126-08
- Chemical Family
- Epoxy & Epoxy Derivatives
126-08 is a screen-printable, B-Stageable, highly thermally conductive, one part epoxy coating and adhesive. This system features excellent thermal stability, outstanding chemical resistance and excellent high temperature properties. Applications include adhesives, printed circuit board fabrication, advanced material composites, sealing and high performance coatings.\nFeatures\nExtremely high thermally conductive epoxy adhesive
Product families
Applications
- Printed Circuit Boards (PCBs)
Product Families
- Conductive Adhesives
Other characteristics
- Product Type
1K (1 component) Adhesive, Conductive Adhesive, Epoxy Adhesive; 1K (1 component) Adhesive; Conductive Adhesive; Epoxy Adhesive
- Application Method
- Injection, Screen Coating
- Markets
- Electrical & Electronics
- Shelf LIfe
- 2 month at 25ºC, 6 months at -10°C
- Technology
- Ready-to-Use Products
- Procedure
Apply adhesive to substrate. Next apply heat to advance the curing to the non-tacky stage (when cooled to room temperature). A temperature of 125°C for 2 - 3 minutes is required (B-Stage time is mass related). User is encouraged to experiment for optimum drying time at a given temperature. Store on release liner to prevent contamination.
- Bonding Procedure
Refer to above for storage information. To use, carefully align parts to be bonded, apply uniform pressure to maintain location. Cure for 30 minutes at 175°C, or 1 hour at 150°C. (Note cure times given are mass related. Timing should start after adhesive and substrates reach curing temperature.)
- Safety and Handling
Use with adequate ventilation.; Keep away from sparks and open flames.; Avoid prolonged contact with skin and breathing of vapors.; Wash with soap and water to remove from skin.
- Application Methods
- Injection
- Screen Coating
- Certifications and Compliance
- ISO 9001
- Suggested Handling and Curing
Material is ready to use as received. Store frozen to maintain consistent flow properties. Allow material to warm up to room temperature before opening container. Prior to using, mix container well to re-suspend fillers. As a coating cure for one (1) hour at 150°C, or 30 minutes at 175°C. 126-08 can be thinned with small amounts of CMI# 113-12 thinner.
- Ready to Use Product Features
- Chemical Resistant
- Excellent Coating Performance
- Good Thermal Stability
- High Modulus
- High Temperature Performance
- Thermally Conductive
Technical data
Table 1 of 1
10 rows| Characteristic | Value | Unit |
|---|---|---|
| Pot Life | Latent | — |
| Conductivity | 6.6 | W/mK |
| Viscosity | 20,000 - 35,000 | cps |
| Thermal Conductivity | 6.6 | W/m-K |
| Glass Transition Temperature | 105 | °C |
| Lap Shear Strength | 1800 | psi |
| Dielectric Strength | 440 | volts/mil |
| Volume Resistivity | 1x10^16 | ohm-cm |
| Dielectric Constant (at 1 Hz) | 5.2 | — |
| Dielectric Factor (60 Hz) | 0.018 | — |
