Oil-Stop™ Primer

Chemical Family: Epoxy & Epoxy Derivatives

Oil-Stop™ Primer is a two-component, solvent-based epoxy coating for coating petroleum-based ND oil-contaminated concrete. This product penetrates the substrate for excellent adhesion and is an ideal primer for the oil-contaminated concrete substrate. Recommended for petroleum oil contaminated substrates. This product is not intended for use over vegetable oil, animal fat or synthetic oil contaminated concrete. This product can withstand exposure to many common solvents and chemicals.

Product families

Applications

Printing & Packaging — Packaging Coatings

Primers & Lacquers

Product Families

Ready-to-Use Products — Paints & Coatings

Primers & Sealers

Other characteristics

Brand: Oil-Stop
Features: Good Adhesion
Product Type: 2K (2 component) Coating, Primer, Solventborne Coating; 2K (2 component) Coating; Primer; Solventborne Coating
Compatible Substrates & Surfaces: Concrete
Color: Black
Markets: Printing & Packaging
Shelf LIfe: 1 year
Finish Coat: Satin gloss (40-60 @ 60°C, Erichsen glossmeter)
Flexibility: No cracks on 1/8" mandrel
Precaution: Use with adequate ventilation.; Avoid contact with eyes, skin and clothing, wear gloves or protective creams - if skin contact occurs, wash at the first opportunity with soap and water.; Eye exposure or inhalation can result in serious medical problems - in the event of eye contact, immediately flush eyes with water and contact a physician.; Keep out of the reach of children.; For industrial use only.
Restrictions: Restrict use of the floor to light traffic and non-harsh chemicals until the coating is fully cured.. It is best to let the floor remain dry for the full cure cycle.
Technology: Ready-to-Use Products
Floor Cleaning: Some cleaners may affect the color of the floor installed.; Test each cleaner in a small area, utilizing your cleaning technique.; If no ill effects are noted, continue to clean with the product and process as tested.
Product Mixing: This product has a 1:1 mix ratio by volume.; After the two parts are combined, mix well with slow-speed mixing equipment such as a jiffy mixer until streak-free.; Improper mixing may result in product failure.
Abrasion Resistance: Taber abraser CS-17 with 1,000 gram total load and 500 cycles = 37.0 mg loss
Application: We recommend due to the vastly varying contamination parameters, it is recommended that the applicator check both the adhesion of this product to the substrate as well as a thorough evaluation of the proposed intermediate and topcoat selections.; Petroleum-based oils have a tendency to migrate upward through newly placed coatings and could cause disbonding if preceding coats are not inspected prior to top coating.; Clean all previous coatings as necessary.; This coating should not be used until a sample has been evaluated for suitability and adequate adhesion.; Make certain that the floor and air temperatures are between 55°F and 90°F (15.5°C and 32.2°C).; Preferably, the relative humidity should be below 90%.; This product should be applied by roller or brush at 5 - 8 mil thickness when wet.

Technical data

Table 1 of 3

2 rows

Characteristic	Value	Unit
VOC (Per Gal.)	2.5	lbs.
Mix Ratio by Volume	1.0	—

Table 2 of 3