QuakeBond™ UVC

Product families

Other characteristics

Brand

QuakeBond

Features

Fast Drying, Good Adhesion, Good Flammability Properties, Good Non-Yellowing Properties, Good Toughness, Good UV Resistance, Low VOC

Product Type

Waterborne Coating

Application Method

Brush, Roller, Spray

Usage

Finish coating compatible with QuakeWrap® wet lay-up, SPiRe™, and PileMedic™ products.; UV resistant coating.

Cleanup

Collect with absorbent material, flush with water.; Clean up using acetone or other ketone solvents.; Dispose waste in accordance with local disposal regulations.

Markets

Building & Construction

Coverage

Applied at a thickness of 15 mils results in 100 ft² per gallon.; Rough and uneven surfaces result in lower yields.

PACKAGING

• 1-gallon
• 5-gallon
• 55-gallon

Advantages

• Rapid recoat time.
• Excellent film formation and building.
• Good UV resistance, non-yellowing.
• Low VOC.

Application

QuakeBond™ UVC can be applied using a sprayer, brush, or roller depending upon the application tools available.; Using any application method, to avoid mud cracking, do not use too much material on a single coating.; During the spray application, there should be approximately 6 to 12 inches between the tip of the spray gun and the substrate.; Adjust the spray gun valve so the gun is spraying a 6-inch fan, using minimal pressure.; A 50% overspray technique is recommended.; For optimal results, a dual coat program should be applied.; First, spray one coat horizontally across a section, and then complete the process next with a vertical spray direction.; Do not spray at high pressure as the mixture might dry before landing on the substrate.; It is acceptable practice to brush hard-to-reach areas after spraying.; Continue to agitate the coating during application.; Let each coat dry to the touch before applying a second layer.; Ensure proper coverage on edges, as during normal hydrolysis induced cure, the material may become thinner than expected.; Brush edges or corners before spraying the surface to ensure enough material is in contact with the substrate.

Show in full

Limitations

Do not apply to materials still in the curing process.; Do not apply to substrates at a temperature less than 50°F (10°C).

Technology

Ready-to-Use Products

Application Methods

• Brush
• Roller
• Spray

Surface Preparation

Substrate surfaces must be structurally sound and free from contaminants such as dust, oil, and dirt.; Surfaces must be shot blasted, abrasively ground, hydro-blasted or mechanically abraded to achieve the required surface profile.; Freestanding water must be removed.

Shelf Life Storage

Store product in original container in a dry location for up to 12 months at 77°F (25°C) or below.; If stored below 25°C, the material must be allowed to come to room temperature, in the sealed container, to avoid moisture contamination.; Material removed from containers may be contaminated during use.; Do not return the product to the original container.; QuakeWrap® cannot assume responsibility for the product which has been contaminated or stored under conditions other than those previously indicated.

Show in full

Application Equipment

An industrial paint sprayer may be used for larger applications.; A paint roller is used for touch-ups, repair, and smaller applications.

Ready to Use Product Features

• Fast Drying
• Good Adhesion
• Good Flammability Properties
• Good Non-Yellowing Properties
• Good Toughness
• Good UV Resistance
• Low VOC