Technicoll® 8153

Product families

Other characteristics

Brand

Technicoll

Product Type

Contact Adhesive

Compatible Substrates & Surfaces

Aluminum, Concrete, Expanded Polystyrene (EPS), Fiberglass, Metal, Plastics, Polystyrene (PS), Wood

Base

Styrene-Butadiene Rubber (SBR)

Markets

• Building & Construction
• Electrical & Electronics

Technology

Ready-to-Use Products

Usage

Surface preparation; Bonding surfaces must be dry and clean, especially free of oil, grease or release agents. In many cases, surface roughening prior to bonding improves strength of bonded joint. It is recommended when working with rubber and metals.; Adhesion; Stir adhesive before use. Apply a thin layer of technicoll® 8153 equally to both sides of the bonding surface of the substrates (brush, trowel, closed roller). After the application solvent needs to evaporate. The usual waiting time is just a few minutes. It depends on the applied amount of adhesive and the indoor climate. The right time for the bonding has come as soon as the applied adhesive does not pull strings anymore when touching with the finger, but still feels very sticky. Join the substrates together accurately and assemble quickly under high pressure. The good bond strength that is achieved immediately, usually allows further processing with the bonded substances right away. In some cases a one-sided application might be possible: Apply a thick layer of technicoll® 8153 equally to one side and join both surfaces immediately. Wait for a couple of days before assessing the final strength.

Show in full

Favoured Substrates

Polystyrene rigid foam (PS, EPS, XPS); Styropor®, Styrodur®; Metals; Bituminised felt; Glass fiber mats with:; Concrete, render; Felt; Aluminum foil; Mineral fiber mats; Derived timber products ●; Plastic films (unplasticised); Not suitable for: PE, PP, PTFE (Teflon®), POM, silicone, EPDM, PVC plasticised (faux leather); Due to the large variety of possible materials and differences in adhesion behavior hazard tests are mandatory before introducing the adhesive into the actual production process.

Show in full

Handling Properties

Dilution - Not Necessary, Possible With Technicoll® 8363.; Cleaning - Cured adhesive can only be removed mechanically.

Field of Application

Bonding of PS – rigid foams and insulation materials, such as mineral or glass fiber mats with metal, bituminised felts, aluminum and different kinds of unplasticised polymeric films.

Maximum Time Of Storage

At least 1 year when stored in sealed original packaging in cool and dry place.

Special Characteristics

Technicoll® 8153 is a fast setting, unfilled contact adhesive with a high resistance to water and heat.

Behaviour At Low Temperature

Not susceptible to frost. Densification at low temperature. Once adjusted to processing temperature: fully employable.

Preferred Storage Temperature

10°C - 25°C

Ready to Use Product Features

• Fast Setting
• Heat Resistance
• Water Resistant

Compatible Substrates and Surfaces

• Aluminum
• Concrete
• Expanded Polystyrene (EPS)
• Fiberglass
• Metal
• Plastics
• Polystyrene (PS)
• Wood