NUDEC® PS
NUDEC®PS plastic sheets are characterized by a high degree of light transmission, which endows them with high transparency. For this reason, they are ideal for inside glazing, frames and ceiling lights.
Properties
- Physical Form
- Sheets
Other characteristics
- Brand
- NUDEC
- Density
- 1050.0 - 1050.0 kg/m³
- Features
Dimensional Stability, Excellent Transparency Properties, Good Brightness, High Rigidity, Low Water Absorption, Microbe Resistant
- Polymer Name
- Polystyrene (unspecified)
- Tensile Modulus
- 3250.0 - 3250.0 MPa
- Markets
- Building & Construction
- Consumer Goods
- Electrical & Electronics
- Storage
An incorrect storage position can lead to permanent deformation.; The sheets should be stored in closed premises that guarantee normal environmental conditions.; The sheets should be stored one on top of the other on flat horizontal surfaces and fully supported over their total area.; The topmost panel should be covered with a sheet of polyethylene or cardboard etc.; NUDEC®PS sheets must not be stored in direct sunlight or under conditions of high humidity and/or temperature as this can have a negative effect of protective film adhesion.
Technical data
Table 1 of 4
7 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Charpy Impact Strength Notched | 1.47 | kJ/m² | ISO 179 |
| Charpy Impact Strength Un-Notched | 16.0 | kJ/m² | ISO 179 |
| Elongation (Breakage) | 3.0 | % | ISO 527 |
| Flexural Strength | 106.0 | % | ISO 527 |
| Rockwell Hardness (M/R Scale) | 150.0 | MPa | ASTM D-785 |
| Tensile Modulus of Elasticity | 3250.0 | MPa | ISO 527 |
| Tensile Strength (Breakage) | 59.0 | MPa | ISO 527 |
Table 2 of 4
1 row| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Density | 1.05 | g/cm³ | ISO 1183 |
Table 3 of 4
6 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Coefficient of Linear Thermal Expansion | 8.0 | 10⁻⁵ / °C | ISO 75-2 |
| Heat Deflection Temperature B (0.45 Mpa) | 98.0 | °C | ISO 75-2 |
| Heat Deflection Temperature A (1.8 Mpa) | 86.0 | °C | ISO 75-2 |
| Maximum Service Temperature | 80.0 | °C | — |
| VICAT Softening Temperature (10 N) | 106.0 | °C | ISO 306 |
| VICAT Softening Temperature (10 N) | 101.0 | °C | ISO 306 |
Table 4 of 4
2 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Light Transmission | 89.0 | % | ASTM D-1003 |
| Refractive Index | 1.591 | — | ASTM D-542 |
