Induron Coatings INDURAGUARD SEMI-GLOSS EPOXY
- Chemical Family
- Epoxy & Epoxy Derivatives
A high build, surface-tolerant, semi-gloss epoxy coating formulated for excellent resistance to corrosive and abrasive environments. This product is available in a wide range of attractive colors and is formulated for excellent adhesion to clean steel, rusted steel, weathered galvanized steel, wood, concrete, and most existing cured coatings. This product meets the requirements of ANSI/AWWA D102- 06 OCS-5 for first coat and intermediate coat and OCS-6 intermediate coat. Complies with U. S. EPA Ozone Transport Commission (OTC) for Volatile Organic Compounds for VOC Emission Standards for industrial maintenance coatings.
Product families
- Protective Coatings
Other characteristics
- Features
Abrasion Resistant, Corrosion Resistant, Long Term Protection, Medium Gloss
- Product Type
- Epoxy Coating
- Application Area
- Pipes, Tanks
- Pipes
- Tanks
- Application Method
- Brush, Roller, Spray
- Compatible Substrates & Surfaces
Aluminum, Carbon Steel, Masonry, Metal, Steel, Wood
- Usage
This product is especially designed to provide long-term protection to primed, unpainted or previously painted steel. It may be used to extend the life of structures previously painted with lead and chromate containing coatings and thus avoid the generation of toxic by-products that sandblasting would entail. This product is ideal for protecting and extending the life of metal buildings, fences, piping, process equipment, tanks, bridges and structural steel.
- Note
Lower temperature, higher film build, and/or poor ventilation will retard dry time. E-60 Accelerator may be used to increase the normal curing rate of reaction to provide a rapid low temperature cure.
- Markets
- Building & Construction
- Industrial
- Paints & Coatings
- Limitations
Not recommended for dry service temperatures exceeding 200°F, or immersion service at temperatures exceeding 120°F. Do not use when substrate temperature is below 45°F.
- Technology
- Ready-to-Use Products
- Recoatability
Induraguard may be used as a single coat, recoated with itself or topcoated with Induron Perma-Clean II Epoxy, Induron Armorguard Epoxy, Induron Indurethane, or Induron Aquanaut© finishes.
- Quality Standards
- American National Standards Institute (ANSI)
Technical data
Table 1 of 2
5 rows| Characteristic | Value | Unit |
|---|---|---|
| Volume Solids | 74 - 76 | % |
| Solids (by Weight) | 84 - 86 | % |
| Weight (Mixed) | 10.8 - 11.8 | lbs/gallon |
| Volatile Organic Contents (Mixed Unthinned) | 2.0 (240) | lbs/gallon (grams/liter) |
| Volatile Organic Contents (Mixed Thinned (10%)) | 2.4 (290) | lbs/gallon (grams/liter) |
Table 2 of 2
7 rows| Characteristic | Value | Unit |
|---|---|---|
| Coverage (Theoretical, at 1.0 mil dry film thickness) | 1171.0 | sq. ft/gal |
| Dry Film Thickness | 3.0 - 7.0 | mils per coat. |
| Wet Film Thickness | 4.1 - 9.6 | mils |
| Pot Life (90°F) | Three hours | — |
| Dry Time to Handle (80°F) | 18.0 | hours |
| Dry Time to Recoat (45°F to 55°F) | 48.0 | hours |
| Dry Time to Recoat (Above 55°) | 24.0 | hours |
