Westcoat EC-11 Water-Based Epoxy

Other characteristics

Features

Chemical Resistant, Durable, Fast Drying, Good Toughness, Long Potlife, Medium Gloss, Moisture Resistant, Water-based

Product Type

2K (2 component) Coating, Primer, Sealer, Waterborne Coating

Application Area

Floor

Application Method

Brush, Roller, Spray, Wipe

Compatible Substrates & Surfaces

Concrete, Masonry, Metal, Wood

Usage

EC-11 is designed to be used on concrete, metal, masonry or wood where a tough, chemical-resistant finish is needed.; EC-11 is recommended for use as a medium-duty concrete sealer for interior floors.; EC11 may also be used as a primer under many Westcoat Systems.

Color

• Black
• Blue
• Green
• Grey
• Red
• Tan
• White
• Yellow

Mixing

Premix each component separately.; For color consistency, box all part A's. In a clean bucket, mix 2 parts A with 1 part B (by volume) of EC-11.; Mix thoroughly with a low speed (400-600 rpm) drill motor for 3-4 minutes.; Make sure to scrape the sides and bottom of the container during mixing.; After mixing is completed, remove material from container within 5 minutes, as epoxy will begin to generate heat.; Spread immediately onto the floor.; As product is spread out, you will have longer working time (10-15 minutes at 70°F).

Show in full

Carrier

Water

Markets

Building & Construction

Clean Up

Uncured material should be removed with soap and warm water.; Cured material should be removed mechanically or with an environmentally-safe solvent.

Coverage

Will vary depending on the mil thickness applied and the porosity and texture of the surface, but in general, EC-11 will cover approximately 300-600 square feet per gallon as a primer, coating or sealer.

Dry Time

You may re-coat as soon as the surface is dry to the touch in 1 to 4 hours, but no later than 24 hours.; Light foot traffic may be permitted in 6 hours, normal traffic in 24 hours and vehicle traffic in 72 hours.; All times are based on average temperature of 70F degrees and 50% humidity.; Cooler temperatures will increase drying time.

Show in full

Moisture

All concrete should be tested for moisture before applying a seamless coating.. If moisture emissions exceed 5 lbs/1000 square feet/24 hours (ASTM F1869) or if the relative humidity (RH) exceeds 75% (ASTM F2170), contact the manufacturer before application.

Pot Life

60 - 90 minutes (Gel Time, 150gm, 72°F)

Thinning

• Thin with water, up to 50%
• Amount will vary depending on use.

PACKAGING

1.5 gal & 15 gal kits available.

Advantages

• USDA/FDA Compliant
• Water based
• Moisture Tolerant
• Chemical Resistant
• Long Pot Life
• Medium Gloss
• Very Durable
• Easy to Use
• 2 more

Inspection

The surface must be structurally sound, clean, dry and free of grease, paint, oil, dust, curing agents, laitance or any foreign material that will prevent proper adhesion.; The concrete should be at least 2,500 PSI and porous or rough enough to allow the product to soak in.; A minimum of 28 days curing time is required on all concrete.; Prior to starting work, test existing concrete slab for efflorescence, moisture and hydrostatic pressure.

Show in full

Shelf LIfe

3 years in unopened packaging