RO3003G2™ Laminates
- Chemical Family
- Fluoropolymers
RO3003G2™ high-frequency ceramic-filled PTFE laminates are an extension of Rogers’ industry leading RO3003™ solutions. RO3003G2 laminates are based on industry feedback to address the next generation needs for mm-wave automotive radar applications.
Product families
- Laminates
Other characteristics
- Brand
- RO3003G2
- Functions
- Laminate
- Markets
- Automotive & Transportation
- Electrical & Electronics
- Technology
- Composite Materials
- Material Features
- Chemical Resistant
- Dimensional Stability
- Good Electrical Properties
- Good Mechanical Properties
- HIGHLIGHTS
The combination of optimized resin and filler content along with the introduction of Very Low Profile ED copper translates to a Dk of 3.00 @ 10 GHz (clamped stripline method) & 3.07 @ 77 GHz (microstrip differential phase length method). These laminates also show very low insertion loss of 1.3dB/inch for 5 mil laminates as measured by the microstrip differential phase length method. RO3003G2 laminates can be fabricated into printed circuit boards using standard PTFE circuit board processing techniques, with minor modifications as described in the application note "Fabrication Guidelines for RO3000® Series High Frequency Circuit Materials."
- Recommended Applications
- Adaptive cruise control
- Forward collision warning
- Active brake assist
- Lane change assist
- Traffic jam pilot
- Parking pilot
- Blind spot detection
- Composite Materials Functions
- Laminate
Technical data
Table 1 of 1
19 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Dielectric Constant, εr, Process | 3.00 ± 0.04 | — | IPC-TM-650 2.5.5.5 Clamped Stripline |
| Surface Resistivity | 2.6 x 10^8 | MΩ | IPC 2.5.17.1 |
| Dielectric Constant, εr, Design | 3.07 | — | Differential Phase Length Method |
| Volume Resistivity | 1.4 x 10^9 | MΩ-cm | IPC 2.5.17.1 |
| Dissipation Factor, tan d | 0.0011 | — | IPC-TM-650 2.5.5.5 |
| Thermal Coefficient of εr | -35 | ppm/°C | IPC-TM-650 2.5.5.5 |
| Dimensional Stability - X axis | -0.16 | mm/m | IPC TM-650 2.2.4 |
| Dimensional Stability - Y axis | -0.14 | mm/m | IPC TM-650 2.2.4 |
| Tensile Modulus - X axis | 378 | kpsi | ASTM D638 |
| Tensile Modulus - Y axis | 396 | kpsi | ASTM D638 |
| Moisture Absorption | 0.06 | % | IPC-TM-650 2.6.2.1 |
| Specific Heat | 0.73 0.83 | J/g/°K | ASTM E1269-11 |
