PERMABOND® ET5393
- Chemical Family
- Epoxy & Epoxy Derivatives
PERMABOND® ET5393 is a 1:1 mixable epoxy adhesive. It is fully toughened and ideal for structural applications exposed impact and vibration stresses. It is ideal for bonding different materials where differential thermal expansion is anticipated. ET5393 can be used to bond a wide variety of materials including plastics, composites and metals – in particular, stainless steel. Unlike many other epoxies, ET5393 is less affected by low temperatures during cure and exhibits a reliable cure in colder conditions.
Product families
- Structural Adhesives
Other characteristics
- Brand
- PERMABOND
- Cure Method
- Air Dry
- Product Type
- 2K (2 component) Adhesive, Epoxy Adhesive
- 2K (2 component) Adhesive
- Epoxy Adhesive
- Compatible Substrates & Surfaces
- Composites, Metal, Plastics
- Markets
- Adhesives & Sealants
- Cure
- Air Dry
- Applications
Adhesives & Sealants — Other Adhesives & Sealants Applications
- Technology
- Ready-to-Use Products
- Use Direction
1. Dual cartridges: a) Insert the cartridge into the application gun and guide the plunger into the cartridge. b) Remove the cartridge cap and dispense material until both sides are flowing. c) Attach the static mixer to the end of the cartridge and begin dispensing the material. 2. Apply material to one of the substrates. 3. Join the parts. Parts must be joined within 15-25 minutes of mixing the two epoxy components. 4. Large quantities and/or higher temperature will decrease the usable life or pot life. 5. Apply pressure to the assembly by clamping for 3 hours or until handling strength is obtained. 6. Full cure will be obtained after 24 hours at 23°C (77°F). Heat can be used to accelerate the curing process.
- Benefits and Features
- Adhesion to a wide variety of substrates
- Full cure at room temperature
- Steady cure at low temperatures
- Easy to apply
- Fully toughened
- Good impact strength
- Storage Temperature
- 5 to 25°C (41 to 77°F)
- Surface Preparation
Surfaces should be clean, dry and grease-free before applying the adhesive. Use a suitable solvent (such as acetone or isopropanol) for the degreasing of surfaces. Some metals such as aluminum, copper and its alloys will benefit from light abrasion with emery cloth (or similar), to remove the oxide layer.
- Certifications and Compliance
- ISO 9001
- Ready to Use Product Features
- Good Impact Strength
- Compatible Substrates and Surfaces
- Composites
- Metal
- Plastics
- Typical Properties (Cured)
- Cured 24 hrs @23°C
- 18-20 N/mm² (2600-2900 psi) Cured 1 hr @ 60°C: 20-23 N/mm² (2900-3300 psi)
- Cured 24 hrs @ 23°C As received
- 16-20 N/mm² (2300-2900 psi) Gritblast/degrease: 19-22 N/mm² (2800-3200 psi) Cured 1 hr @ 60°C As received: 21-25 N/mm² (3000-3600 psi) Gritblast/degrease: 23-26 N/mm² (3300-3800 psi)
- Cured 1hr @ 60°C
- 210-230 N/25mm (46-50 PIW) Cured 5 days @ 23°C: 180-200 N/25mm (33-44 PIW)
