PERMABOND® ES569
- Chemical Family
- Epoxy & Epoxy Derivatives
PERMABOND® ES569 is a single-part heat cured epoxy adhesive with excellent adhesion to metal surfaces as well as composite materials. The high bond strength of this adhesive allows it to replace mechanical fastening, soldering, brazing or welding. ES569 has been designed to be non-sagging, allowing the product to be used in large gaps and on vertical surfaces. It is also ideal for bonding electronic components as it has high wet strength and is non-stringing and produces an excellent drop profile as well as withstanding solder reflow processes.
Properties
- Physical Form
- Paste
Product families
Applications
- Consumer Goods — Appliances & Electronics; Adhesives & Sealants — Other Adhesives & Sealants Applications
- Adhesives & Sealants
Product Families
- Structural Adhesives
Other characteristics
- Brand
- PERMABOND
- Cure Method
- Heat Cure
- Product Type
- 1K (1 component) Adhesive, Epoxy Adhesive
- 1K (1 component) Adhesive
- Epoxy Adhesive
- Compatible Substrates & Surfaces
- Composites, Metal
- Markets
- Adhesives & Sealants
- Consumer Goods
- Electrical & Electronics
- Cure
- Heat Cure
- Technology
- Ready-to-Use Products
- Use Direction
The adhesive should be dispensed from the bottle via the nozzle supplied (this can be cut to give the appropriate sized bead to cover the bond area).; Apply the adhesive to one surface and avoid entrapping air.; Assemble parts applying sufficient pressure to ensure the adhesive spreads to cover the entire bond area.; Use a jig / clamp to prevent parts moving during cure.; It is advisable not to disturb the joint until the adhesive is fully cured.; Cure with heat – see page one for cure schedule.
- Benefits and Features
- Excellent adhesive strength
- Excellent resistance to vibration
- Easy to use – no mixing required
- High shear and peel strength
- High temperature resistance
- Good resistance to chemicals
- Non-sag, thixotropic
- Storage Temperature
- 2 to 7°C (35 to 45°F)
- Surface Preparation
Surfaces should be clean, dry and grease-free before applying the adhesive. Use a suitable solvent (such as acetone or isopropanol) for the degreasing of surfaces. Some metals such as aluminum, copper and its alloys will benefit from light abrasion with emery cloth (or similar), to remove the oxide layer.
- Certifications and Compliance
- ISO 9001
- Ready to Use Product Features
- Chemical Resistant
- Good Adhesion
- Good Bonding Strength
- Good Sagging Resistance
- Temperature Resistance
- Thixotropic
- Compatible Substrates and Surfaces
- Composites
- Metal
- Typical Properties (Cured)
Steel 27 – 41 N/mm² (4000 – 6000 psi) Aluminum 17 - 31 N/mm² (2500 – 4500 psi) Zinc 14 - 27 N/mm² (2000 – 4000 psi) FRP Glass/Epoxy 9-11 N/mm² (1300–1600psi) Carbon Fiber 10-12 N/mm² (1450–1700psi)
