PERMABOND® ES558
- Chemical Family
- Epoxy & Epoxy Derivatives
PERMABOND® ES558 is a single-part epoxy paste which flows like solder when heated during curing. The adhesive is toughened for maximum impact resistance, along with excellent peel and shear strength. ES558 is ideal for bonding a wide range of materials including metals, ferrites, ceramics and composites.
Properties
- Physical Form
- Paste
Product families
- Structural Adhesives
Other characteristics
- Brand
- PERMABOND
- Cure Method
- Heat Cure
- Product Type
- 1K (1 component) Adhesive, Epoxy Adhesive
- 1K (1 component) Adhesive
- Epoxy Adhesive
- Compatible Substrates & Surfaces
- Ceramic, Composites, Metal
- Markets
- Adhesives & Sealants
- Cure
- Heat Cure
- Applications
Adhesives & Sealants — Other Adhesives & Sealants Applications
- Technology
- Ready-to-Use Products
- Use Direction
The adhesive should be dispensed from the cartridge via the nozzle supplied (this can be cut to give the appropriate sized bead to cover the bond area).; Apply the adhesive to one surface and avoid entrapping air.; Assemble parts applying sufficient pressure to ensure the adhesive spreads to cover the entire bond area.; Use a jig / clamp to prevent parts moving during cure.; It is advisable not to disturb the joint until the adhesive is fully cured.; Cure with heat – see page one for cure schedule.
- Benefits and Features
- Excellent adhesive strength
- Excellent resistance to vibration
- Easy to use – no mixing required
- High shear and peel strength
- Good impact strength
- High temperature resistance
- Good resistance to chemicals
- Storage Temperature
- 2 to 7°C (35 to 45°F)
- Surface Preparation
Surfaces should be clean, dry and grease-free before applying the adhesive. Use a suitable solvent (such as acetone or isopropanol) for the degreasing of surfaces. Some metals such as aluminum, copper and its alloys will benefit from light abrasion with emery cloth (or similar), to remove the oxide layer.
- Certifications and Compliance
- ISO 9001
- Ready to Use Product Features
- Chemical Resistant
- Good Adhesion
- Good Impact Strength
- High Impact Resistance
- Temperature Resistance
- Compatible Substrates and Surfaces
- Ceramic
- Composites
- Metal
- Typical Properties (Cured)
Steel 27 – 41 N/mm² (4000 – 6000 psi) Aluminum 17 - 31 N/mm² (2500 – 4500 psi) Zinc 14 - 27 N/mm² (2000 – 4000 psi); >14 N/mm² (>2000 psi) Substrate failure
