Mascoat® 400DFP
- Chemical Family
- Silicones
Mascoat® 400DFP is a hi-temp dry fall silicone copolymer primer designed for heated substrates up to 400°F. The one-part coating’s dry fall properties allow it to dry to a powder within 10 - 20 feet from point of application, allowing it to safely be used in areas where overspray damage to nearby cars and equipment would be a concern. It offers maximum adhesion and corrosion protection even in limited surface preparation areas and does not require a heat cure. Engineered specifically for heavy industrial equipment, M-400DFP may be used on any service area ranging from ambient to 400°F for premium corrosion protection.
Product families
Applications
- Industrial Coatings
Product Families
- Primers & Sealers
Other characteristics
- Brand
- Mascoat
- Features
Chemical Resistant, Corrosion Resistant, Good Adhesion, Good Substrate Wetting, High Flexibility, Low VOC, Water Resistant; Excellent corrosion protection; Good chemical resistance; Excellent flexibility; Unlimited recoat window; Excellent edge protection; Single coat capability; Outstanding wetting & adhesion properties; VOC Compliant
- Product Type
- 1K (1 component) Coating, Primer
- 1K (1 component) Coating
- Primer
- Application Method
- Brush, Roller, Spray
- Compatible Substrates & Surfaces
- Metal, Steel
- Finish
- Flat
- Safety
For minimum protection, Mascoat recommends an N95 particulate respirator mask. For additional protection, a half mask respirator with organic vapor cartridge can be utilized. Eye protection recommended due to spray application method.
- Markets
- Paints & Coatings
- Clean Up
- Cleanup with Reducer 1-400 or Reducer 2-400.
- PACKAGING
Packaging - 1 gallon and 5 gallon pails.; Weight - 1 gallon pail weighs 14lbs and 5 gallon pail weighs 17lbs.
- Limitations
- Applications should not exceed 400˚F.
- Technology
- Ready-to-Use Products
- Storage Condition
Mascoat® 400DFP should be stored at temperature 20˚F - 110˚F.
- Application Methods
- Brush
- Roller
- Spray
- Application Conditions
Dry-Fall Application Instructions - To ensure dryfall effect, do not apply in temperatures below 45˚F, on surfaces below 40˚F, or humidity above 85% RH. When humidity is above 50%, take caution to observe the dry-fall range as it may extend slightly past the 20' mark, up to 50' depending on other weather variables. Make sure the equipment being used will give accurate psi readings so the pressure from the pump can be maintained at 1800 psi allowing a maximum ±25 psi for surges. Do not apply in temperatures that are 5˚F or less from the dew point.
Technical data
Table 1 of 1
9 rows| Characteristic | Value | Unit |
|---|---|---|
| Reducer (Mascoat Reducer 1-400) | max. 70 | °F |
| Reducer (Mascoat Reducer 2-400) | min. 70 | °F |
| Volume Solids Content (Mixed) | 43.0 | % |
| Wet Film Thickness | 127 - 178 | µ/Coat |
| Dry Film Thickness | 51 - 76 | µ/Coat |
| Theoretical Dry Coat Coverage (5 mils) | 345.0 | ft²/gal |
| VOC Content (Unthinned) | 3.7 | g/l |
| VOC Content (Mascoat Reducer 1-400) | 0.0 | g/l |
| VOC Content (Mascoat Reducer 2-400) | 0.0 | g/l |
