Nexa3D xMODEL 2505
- Chemical Family
- Methacrylates
Nexa3D xMODEL 2505 is a high resolution dental model material suitable for modeling and thermoforming applications. It is a meth-acrylate based resin suitable for use on Nexa3D printers, including NXE400 and NXD200.printers. Curing profiles are developed for 100 and 50 µm layer heights.
Product families
Applications
- Tooling & Moldmaking
- Dental
Product Families
- Photoactive Resins
Other characteristics
- Density
- 1100.0 - 1100.0 kg/m³
- End Uses
Dental Applications, Modeling Material, Prototyping
- Tensile Strength
- 54.0 - 54.0 MPa
- Processing Methods
- 3D Printing, Stereolithography
- Color
- Beige
- Markets
- Healthcare & Pharma
- Industrial
- Usage Notes
The material should be processed at room temperature. Nexa3D xMODEL 2505 should be well mixed before each print job, color deviation or failed prints might occur when not mixed thoroughly. It's recommended to use a bottle roller (roller bench) for mixing with suitable ceramic beads for at least 30 minutes. Pour it slowly in the vat and wait a couple minutes, until the bubbles are gone before starting the print job. Keep container tightly closed in a room temperature, well-ventilated place. Keep container dry. If Material is not being used fill it back through a filter in the corresponding material bottle. The filter prevents to fill cured pieces or failed prints back into the bottle. Uncured Nexa3D xMODEL 2505 must be disposed of or incinerated in accordance with local regulations. The mechanical and physical properties of Nexa3D xMODEL 2505 are highly dependent on the printing parameters used as well as part geometry. It is common that validated workflows need to be adjusted for unusually thick or thin geometries.
- Technology
- Plastics
- Plastics and Elastomers End Uses
- Dental Applications
- Modeling Material
- Prototyping
- Plastics and Elastomers Functions
- Resin
- Plastics and Elastomers Processing Methods
- 3D Printing
- Stereolithography
Technical data
Table 1 of 2
5 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Tensile Stress at Break | 54 | MPa | ASTM D638 |
| Young’s Modulus | 2500 | MPa | ASTM D638 |
| Elongation at Failure | 4 | % | ASTM D638 |
| Flexural Strength | 83 | MPa | ASTM D790 |
| Flexural Modulus | 2150 | MPa | ASTM D790 |
Table 2 of 2
4 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Hardness | 73 | Shore D | ASTM D2240 |
| Viscosity (30°C) | 80 | mPas | Cone/Plate Rheometer |
| Liquid Density | 1.1 | g/cm³ | ASTM D4052-18a |
| Solid Density | 1.2 | g/cm³ | ASTM D792 |
