ELASTOSIL® LR 3846/20 A/B
- Chemical Family
- Silicones
ELASTOSIL® LR 3846/20 A/B is a considerable oil-bleeding, liquid silicone rubber of the ELASTOSIL® LR 3846 series. It is a paste-like, readily pigmentable, two-component product with a short curing time. Shortly after the curing process, a slight, thin oil film with lubricating properties forms on the surface of the vulcanizates. The vulcanizates are opaque, have good mechanical and electrical properties, and have very low compression sets.
Properties
- Physical Form
- Paste
Product families
- Silicone Elastomers
Other characteristics
- Brand
- ELASTOSIL® LR
- End Uses
Automobile Door Seals, Automotive Connector Seals, Batteries, Cables
- Features
Cost Effective, Excellent Lubricity, Excellent Opacity, Fast Curing, Good Electrical Properties, Good Mechanical Properties, Heat Stabilized, High Bleed Resistant, Low Compression Set, Low VOC, Low Volatility, Pigmentable
- Polymer Name
- Liquid Silicone Rubber (LSR)
- Tear Strength
- 16.0 - 16.0 kN/m
- Note
- Cure conditions : 5 min / 165°C in press.
- Markets
- Automotive & Transportation
- Electrical & Electronics
- Industrial
- Properties
This product can be used within a temperature range of - 55°C to + 210°C. The addition of heat stabilizers at service temperatures of more than 180°C is recommended.
- Technology
- Elastomers
- Packaging Type
- Drums
- Pails
- Specific Features
- Fast curing
- Low compression set without post-cure
- Oil bleeding
- Reduced volatile content
- Additives Included
- Heat Stabilizer
- Material Features
- Cost Effective
- Excellent Lubricity
- Excellent Opacity
- Fast Curing
- Good Electrical Properties
- Good Mechanical Properties
- Heat Stabilized
- High Bleed Resistant
- Storage Information
Once opened, containers should always be resealed after use to prevent the platinum catalyst from being poisoned by amines, sulfur or phosphorus compounds.
Technical data
Table 1 of 2
7 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Compression Set (at 22 hours, 175°C) | 16 | % | DIN ISO 815-1 type B method A |
| Density | 1.09 | g/cm³ | DIN EN ISO 1183-1 A |
| Elongation (at break) | 800 | % | ISO 37 Type 1 |
| Fluid Content | approx. 6 | % | — |
| Shore Hardness A | 21 | — | DIN ISO 48-4 |
| Tear Strength | 16 | N/mm | ASTM D 624 B |
| Tensile Strength | 6.1 | N/mm² | ISO 37 Type 1 |
Table 2 of 2
2 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Dynamic Viscosity (Shear rate 1 s⁻¹) | 730000 | mPa·s | DIN EN ISO 3219 |
| Dynamic Viscosity (Shear rate 10 s⁻¹) | 200000 | mPa·s | DIN EN ISO 3219 |
