Neyra Industries POLYPRO
Neyra PolyPro is a premium quality pavement coating composed of refined coal tar that is fortified with rubber prior to emulsification. In addition, Neyra PolyPro contains a unique surfactant formulation that allows greater compatibility with asphalt surfaces
Product families
Applications
- Coatings & Markings
Product Families
- Primers & Sealers
Other characteristics
- Features
- Chemical Resistant, Excellent Compatibility, Gasoline Resistant, High Solids Content, Oil Resistant, Skid Resistant, Superior Surface Quality, Waterproofing
- Ultimate protection
- The high solids, polymer modified formula provides increased resistance to oil, gasoline and chemicals
- Maximum Durability
- You can expect up to three times the wear of other pavement coatings
- Easy to Use
- Neyra PolyPro comes in a ready-to-use formula
- Safer & Easier to Clean
- Neyra PolyPro creates a seamless, skid-resistant and even-textured surface
- PolyPro's tough, tight, waterproof seal is the longest lasting pavement coating.
- Product Type
- Sealer
- Compatible Substrates & Surfaces
- Asphalt
- Markets
- Building & Construction
- PACKAGING
- 55-Gallon Steel Drum
- Bulk
- Application
For use over sound asphalt pavement, the following application procedures are recommended for best results:. One gallon will cover 90 square feet. Multiply square yards of surface x 0.1 to determine gallons of concentrate per coat.
- Technology
- Ready-to-Use Products
- Ready to Use Product Features
- Chemical Resistant
- Excellent Compatibility
- Gasoline Resistant
- High Solids Content
- Oil Resistant
- Skid Resistant
- Superior Surface Quality
- Waterproofing
- Compatible Substrates and Surfaces
- Asphalt
- Mix Design (Based on 100 Gallon)
Neyra PolyPro is designed to be mixed with mineral aggregate to create a ready-to-use pavement coating. Minimal dilution with water may be required for workability. Do not over dilute.. All sand used should be clean, dry, pure silica and free of contaminants. Medium fine sand with an A.F.S. rating of 50 to 70 gives best results. There should be no more than 2% retained on 30 mesh or coarser, no more than 10% retained on 140 mesh and no more than 0.3% retained on 200 mesh.
