Hitac Adhesives and Coatings RA-23S

Product families

Other characteristics

Features

Low Energy Consumption, Low VOC, Water Resistance

Functions

Release Agent

Labeling Claims

Low VOC

Compatible Polymers & Resins

Acrylics, Natural Rubbers (NR), Polyesters, Polypropylenes (PP), Polyvinyl Chloride (PVC), Synthetic Rubbers

Carrier

Solvent-based

Markets

• Adhesives & Sealants
• Printing & Packaging

Appearance

Clear, Clear to slightly tan

Technology

CASE Ingredients

HIGHLIGHTS

RA-21S-T is a high total solids solution of a polyurethane release agent in toluene. It offers significant improvements over other release agents, such as PVODC. While most release agent solutions must be maintained above ambient temperatures (~75ºF or 25ºC) by heating to prevent precipitation of the release agent on transfer, storage and coating, RA-21S-T is stable without heating, even below freezing temperatures, at all concentrations of its solutions. The absence of a heating requirement reduces energy cost, fire hazards, and the possibility of clogging the gravure rolls that could cause inadequate coat weight and thus yielding excessive unwind adhesion and wasted rolls of tape. Compared to solid release agents, the active ingredient in RA-21S-T is pre-dissolved in toluene. It replaces the dissolving process with a simple dilution that reduces or completely eliminates time, labor, heat, mechanical energy, quality control for making sure all the powder is dissolved, VOC emission, workers exposure to toluene, fire hazard and dusting. Furthermore, the dilution process with RA-21S-T is simple, fast and may be automated, thus yielding more consistent release. RA-21S-T allows the production of tapes with outstanding water resistance even at high temperatures. Unlike other release agents, RA-21S-T may be applied to both rough and porous substrates at high total solids to produce specialty tapes, such as steam sterilizing paper tape, which is not practical with other release agents. RA-21S-T is functional for tapes with most types of adhesives, including SIS, SIS/SB, SBR, natural rubber and acrylic-based adhesives, and most backings, such as polypropylene, polyethylene, polyester, PVC and paper. Coater-ready solutions for film tape applications are easily prepared by mixing one part RA-21S-T with 1 - 100 parts toluene, depending on the adhesive, coat weight, substrate and coating method. The solution may be used as delivered or diluted with toluene or a VOC-exempt solvent, such as acetone, dimethyl carbonate, and propylene carbonate. Application methods for film substrates include Meyer rod #3-12, Anilox and rotogravure roll #160-350. For most tape applications 0.2-1.5% TS yields balanced release properties. For initial trial, use the same level of total solid of RA-21S-T as PVODC. Release properties develop by simply flashing off toluene in an oven usually at 120-170ºF (50-75ºC), depending on substrate, web speed, oven length, air temperature, air velocity, and oven design. Unlike silicone release agents, crosslinking is neither occurring, nor necessary on drying or tape storage. These properties allow release coating and adhesive coating in a single step without the possibility of contamination of the adhesive by partially crosslinked release agent.

Show in full

Unwind Adhesion Value

BASED ON PREMIUM OPP PACKING TAPE WITH SIS-BASED PSA

Compatible Polymers and Resins

• Acrylics
• Natural Rubbers (NR)
• Polyesters
• Polypropylenes (PP)
• Polyvinyl Chloride (PVC)
• Synthetic Rubbers

Compatible Substrates and Surfaces

Paper