ReACT® 761
Hernon ReAct® 761 is a tough acrylic adhesive designed primarily for bonding permanent magnets. ReAct® 761 has also found wide acceptance in a variety of structural bonding applications due to its versatile performance capabilities. ReAct® 761 provides high tensile strength while maintaining excellent product flexibility. This results in tough durable bonds with outstanding impact and peel resistance. ReAct® 761 is a single component adhesive used in combination with Hernon® Activator 59, Activator 56 or Activator 63 for curing at room temperature. The adhesive may also be heat cured at 150ºC.
Properties
- Physical Form
- Liquid
Product families
- Structural Adhesives
Other characteristics
- Brand
- ReACT
- Cure Method
- Air Dry
- Product Type
- 1K (1 component) Adhesive, Structural Adhesive
- 1K (1 component) Adhesive
- Structural Adhesive
- Markets
- Adhesives & Sealants
- Storage
ReAct® 761 should be stored in a cool, dry location in unopened containers at a temperature between 45ºF to 85ºF (7ºC to 29ºC) unless otherwise labeled. Optimal storage is at the lower half of this temperature range. To prevent contamination of unused material, do not return any material to its original container.
- Cure
- Air Dry
- Applications
Adhesives & Sealants — Other Adhesives & Sealants Applications
- Technology
- Ready-to-Use Products
- Benefits
High impact and shock resistance.; Good gap filling capabilities.; High temperature resistance.; Excellent adhesion to a variety of surfaces.; Consistent rate of cure in 60º to 100ºF.; Consistent bond strength.; Eliminates need for mechanical clips.; Requires minimal clamping time.; Room temperature cure, eliminates high cost of energy needed for heat cured material.
- General Information
This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as a sealant for chlorine or other strong oxidizing materials. For safe handling information on this product, consult the Safety Data Sheet (SDS). Where aqueous washing systems are used to clean the surfaces before bonding, it is important to check for compatibility of the washing solution with the adhesive. In some case, these aqueous washes can affect the cure and performance of the adhesive. This product is not normally recommended for use on plastics (particularly thermoplastic materials where stress cracking of the plastic could result). Users are recommended to confirm compatibility of the product with such substrates.
- Cured Performance
- Tested at RT according to ASTM D1002
- Certifications and Compliance
- ISO 9001
- Ready to Use Product Features
- Chemical Resistant
- Excellent Flexibility
- Excellent Solvent Resistance
- Excellent Substrate Adhesion
- Good Gap Filling Capabilities
- High Impact Resistance
- High Temperature Resistance
- High Tensile Strength
