STEOL® TSP-16N
- CAS Number
- 119432-41-6
- EC Number
- 601-612-6
STEOL® TSP-16N is an anionic surfactant used as an emulsifier or dispersant in a variety of agricultural applications. Steol tsp-16n can be used as an anionic emulsifier or dispersant in a variety of agricultural applications, including suspension concentrates and other liquid and dry formulations. Steol tsp-16n is expected to be biodegradable. The product is kosher-certified.
Properties
- Physical Form
- Liquid
Identification
- Chemical Name
Polyethylene glycol mono(tristyrylphenyl) ether sulfate ammonium salt
Product families
Applications
- Agricultural Pest Control
Product Families
- Dispersants & Emulsifiers
- Stickers Surfactants & Wetting Agents
Other characteristics
- Brand
- STEOL
- Functions
Dispersant, Emulsifier, Surfactant, Surfactant (Anionic)
- Markets
- Agriculture & Feed
- Appearance
- Viscous liquid (at 25°C)
- Clearances
The international inventories (country clearances) of STEOL TSP-16N can be found in Section 15 of the Safety Data Sheet (SDS). It is the responsibility of the formulator to review the chemical control regulations for each country where the end-product is intended to be sold or used. If you have any further questions regarding inventories, please contact North America Technical Service at techserv@stepan.com.. STEOL TSP-16N is approved for use as inert ingredient under U.S. EPA 40 CFR 180.920.
- Soluble In
- Water, Methanol, Xylene
- Insoluble In
- Kerosene
- Technology
- Agrochemicals
- Health Effects
STEOL TSP-160N is expected to be practically nontoxic orally (LD₅₀ > 5000 mg/kg) and slightly irritating to the skin and eyes at 100% active.
- Packaging Type
- Bulk
- Drums
- Totes (IBC)
- Biodegradability
- STEOL TSP-16N is expected to be biodegradable.
- Formulation Type
- Capsule Suspensions
- Concentrated Aqueous Emulsions
- Emulsifiable Concentrates
- Microemulsions
- Oil in Water Emulsions
- Suspension Concentrates
- Suspoemulsions
- Standard Packaging
STEOL TSP-16N is available in drums, totes, or bulk quantities.
- Handling
- Safety precautions
- Gloves and safety goggles or a face shield, if splashing may occur, should be employed when handling STEOL TSP-16N. Avoid contact with eyes and skin. Wash hands thoroughly after handling materials.
- Bulk storage information
- Elevated temperature may be desirable to maintain ease of pumping, but product should be stored long-term at ambient temperature. STEOL TSP-16N that has been stored in drums at temperatures below 42°F (6°C) may thicken or solidify. Product may be fluidized by warming with a drum heater or in a steam room. Drums should be vented prior to heating to avoid excessive pressure build up. Product temperatures over 130°F (54°C) are not recommended. Store product dry. Avoid introduction of moisture to drum.
- Workplace Exposure
Occupational exposure can occur primarily through skin contact or via inhalation of vapors and mists. Engineering controls, personal protective equipment, and other workplace safety practices should be used to control these exposures. See SDS for more information.
- Chemical Inventories
- AICS (Australia)
- DSL (Canada)
- ECL (Korea)
- IECSC (China)
- NZIoC (New Zealand)
- TCSI (Taiwan)
- Agrochemical Functions
- Dispersant
- Emulsifier
- Surfactant
- Surfactant (Anionic)
- Certifications and Compliance
- Kosher
- RSPO MassBalance Certified
Technical data
Table 1 of 1
9 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Average Moles of Ethylene Oxide | 25 | — | — |
| Color | max. 300 | — | Apha Scale |
| Density (at 25°C) | 1.15 | g/cm³ | — |
| Density (at 50°C) | 1.13 | g/cm³ | — |
| Flash Point | min. 94 | °C | PMCC Flash Point Tester |
| Moisture Content | 0.05 | % | — |
| pH (5% in 1:1 IPA/H₂O, at 25 °C) | 5.5 | — | — |
| Pour Point | 15 | °C | — |
| Viscosity (at 25°C) | 750 | cPs | — |
