DynaSpec® MIL-PRF-22750 High Gloss

Product families

Other characteristics

Brand

DynaSpec

Features

Good Weather Stability, High Gloss, Military Grade

Product Type

Solventless & High Solids Coating

Application Method

Brush, Roller, Spray

Compatible Substrates & Surfaces

Metal, Steel

Markets

• Industrial
• Paints & Coatings

Technology

Ready-to-Use Products

Application Methods

• Brush
• Roller
• Spray

Primers

Recommended Primer; MIL-PRF-23377 or MIL-PRF-85582 Epoxy Primers, Consult Contract Requirements; DOD-P-15328 or MIL-C-8514C Wash Primer, Consult Contract Requirements; MIL-DTL-53022 or MIL-DTL-53030 Epoxy Primers, Consult Contract Requirements; Due to the wide variety of wood substrates, system performance should be tested and confirmed on actual substrate.; Surface should be intact and sound. All loose and flaking material removed and bare spots primed with an appropriate primer. An area should be tested with the coating to assure compatibility.; MIL-DTL-53022 or MIL-DTL-53030 Epoxy Primers, , Consult Contract Requirements; Due to the wide variety of wood substrates, the system performance should be tested and confirmed on actual substrate.

Show in full

Surface Preparation

Do not apply if the application surface temperature is below 45°F (7°C) or above 110°F (43°C), or if the sruface temperature is within 5°F of the dew point. It is highly recommended that sound practices as set forth by SSPC or NACE be followed when preparing a substrate for painting. At a minimum the surface should be clean of all grease, dirt, oil, rust and foreign material that would be detrimental to proper adhesion and desired performance of the coating system being applied.

Show in full

Application Equipment

Cap

Medium/Heavy Visc. Tip: 1.5-1.8 mm

Cap

Heavy Visc. Tip: 1.8-2.0 mm

Cap

Medium Visc. Tip: 0.11-0.13

Brush and Roll

Utilize a High Quality China or Natural bristle brush or high-density foam core roller for best results.

*Note

The above parameters are to be used as a guideline only. Customer specific equipment may require a different set-up.

Applications

Mix Ratio

4 parts Component A to 1 part 22750G Component B. 1-gallon kits are supplied as a short filled gallon of A and a short filled quart of 22750G Component B. Reducer : Ideal reducer is T-236 Epoxy Reducer (MIL-T-81772B Type II) Cleaning Solvent : T-236 Epoxy Reducer is recommended cleaning solvent. Pot Life: 4-6 hours, Pot life diminishes as temperature rises.

Force Cure

This product can be force cured for approximately 30 minutes at 150-180o F after a 20-30 minute flash off time.

Ready to Use Product Features

• Good Weather Stability
• High Gloss
• Military Grade

Handling Conditions

Shelf life (protected from atmospheric moisture): 12 months from the date of manufacture. This product must be stored in accordance with local, state, and national regulations. Preferred storage conditions: Keep containers in a dry space with adequate ventilation.

Compatible Substrates and Surfaces

• Metal
• Steel