NANOMYTE® SuperAi
NANOMYTE® SuperAi is a nanocomposite coating that imparts anti-icing properties to the underlying substrate. The transparent coating also provides a hard, dense and smooth finish. Surfaces treated with SuperAi exhibit reduced ice adhesion, thereby preventing ice buildup. SuperAi can be applied to a variety of substrates, including plastics, metals, glass, and ceramics. In some instances, a suitable primer may be required for maximum adhesion of the anti-ice coating. The coating can be cured at room temperature.
Product families
- Protective Coatings
Other characteristics
- Brand
- NANOMYTE
- Features
Corrosion Resistant, Good Adhesion, High Durability; Decreases ice adhesion by 60 to 80%; Transparent and glossy finish, with low haze; Dries thin: < 1 mil; Low VOC; Product can be applied to a variety of substrates; Low viscosity formulation spreads quickly – even over complex surfaces
- Product Type
- 1K (1 component) Coating
- Application Method
- Brush, Dip Coating, Roller, Spray
- Compatible Substrates & Surfaces
- Ceramic, Glass, Metal, Plastics
- Curing
- Ambient Curing
- Under ambient conditions (25°C / 77°F, 50% RH), a single coat will be dry to the touch in 1 hour and completely cured in 24 hours.
- Accelerated Curing
- In order to accelerate curing, let the coated surface dry in ambient air for 10 minutes and then heat to at least 105°C for a minimum of 5 minutes, preferably ~15 minutes. An oven, blow dryer, or heat gun may be used (maximum temperature is 150°C).
- Benefits
Weather Resistant - Hydrophobic surface repels water and reduces ice build up; Easy-to-Clean - Lower friction, slippery surface makes it resistant to contamination and easier to clean up; Easy Application - Can be applied by brush, spray, or wipe, with no primer or curing required; Durability - Increases the service life of coating by preserving protective functions; Cost Savings - Reduces raw material, labor, and energy cost of repainting or recoating; Maintenance - Eliminates the need to frequently repaint or replace damaged coatings
- Clean Up
Clean tools and flush equipment immediately after application is completed with acetone thoroughly before product dries. Once coating is dry, the tools will not clean with acetone or any other solvent.
- Technology
- Ready-to-Use Products
- Packaging Type
- Bottles
- Drums
- Application Methods
- Brush
- Dip Coating
- Roller
- Spray
Technical data
Table 1 of 2
1 row| Characteristic | Value | Unit |
|---|---|---|
| Solids Content | 18 - 20 | % |
Table 2 of 2
4 rows| Characteristic | Value | Unit |
|---|---|---|
| Coverage | 110 (1200) | m² (ft²/gallon) |
| Cured Film Thickness | 5 - 15 | μm |
| Curing Temperature | 20 - 150 | °C |
| Water Contact Angle | 100 - 105 | degree |
