NANOMYTE® SuperCN

Other characteristics

Brand

NANOMYTE

Features

Abrasion Resistant, Anti-Fouling, Excellent Hydrophobic Properties, Good Adhesion, Good Erosion Resistance

Product Type

2K (2 component) Coating

Application Method

Dip Coating, Flow Coat, Roller, Spin Coat, Spray

Compatible Substrates & Surfaces

Coated Surfaces, Fibers & Fabrics, Glass, Metal, Plastics, Titanium

Curing

NANOMYTE® SuperCN is thermally cured at an elevated temperature. Recommended curing conditions:

PMMA

4 hours at 85°C

Polycarbonate

1 hour at 120°C

Other

30 minutes at 150°C (for substrates that can withstand high temperatures)

Shorter cure times / reduced temperatures may also be used depending on surface properties and performance requirements; test samples for desired performance when deviating from recommendations.

Markets

• Consumer Goods
• Paints & Coatings

Clean Up

Clean tools and flush equipment thoroughly with acetone before product dries. Once coating is dry, the tools will not clean with acetone or any other solvent.

Technology

Ready-to-Use Products

Application Methods

• Dip Coating
• Flow Coat
• Roller
• Spin Coat
• Spray

Abrasion Resistance

* Taber abrasion test, polycarbonate substrate, CS - 10F wheels, 500g load, 500 cycles

Coating Application

It is recommended that coating application be performed in a clean environment to minimize surface defects. To make the coating solution, in a dust-free container combine Part A and Part B using the following ratio: 3:1 (A:B) in weigth. Mix well by stirring briefly (avoid vigorous stirring to minimize foam formation). The coating may be applied immediately after mixing by dipping, flowing, spinning, rolling or spraying. For spray application of the coating, an HVLP spray gun with a nozzle size of < 1.0 mm is recommended, and the pressure should be set to approximately 25 to 30 psi. For best coating performance, use the coating solution within 24 hours after mixing, or store the mixed solution in a freezer for later use. If stored in freezer, warm the solution up to room temperature before application.

Show in full

Surface Preparation

Ensure surfaces to be coated are clean and dry – the surfaces should be water-break free before coating application. The coating can be applied with or without the use of a primer depending on the substrate. NEI supplies a primer product, NANOMYTE® SR-Primer, which works well with a range of plastics. The primer may be applied by dipping, flowing, spinning, rolling or spraying. For spray application of the primer, an HVLP spray gun with a nozzle size of < 1.0 mm is recommended, and the pressure should be set at approximately 25 to 30 psi. The primed parts should then be dried at 70ºC for 10 min before application of NANOMYTE® SuperCN.

Show in full

Storage and Handling

Precautions for Safe Handling Appropriate personal protective equipment should be used at all times. Avoid contact with eyes, skin and clothing. Provide good ventilation or extraction and avoid prolonged or repeated breathing of vapor. Keep away from heat, sparks, flames and other sources of ignition. Wash hands thoroughly after handling. Conditions for Safe Storage For best coating performance, store Part B in a freezer or a refrigerator. Keep the containers of Part A tightly sealed and store in a cool and dry place. Avoid storage above 30 °C / 86 °F and contamination with incompatible materials. Keep away from heat, sparks, flames and other sources of ignition. Residual vapors might explode on ignition.

Show in full

Ready to Use Product Features

• Abrasion Resistant
• Anti-Fouling
• Excellent Hydrophobic Properties
• Good Adhesion
• Good Erosion Resistance

Compatible Substrates and Surfaces

• Coated Surfaces
• Fibers & Fabrics
• Glass
• Metal
• Plastics
• Titanium