CIM® 1061
CIM® 1061 is a tough, abrasion, corrosion and chemical resistant, liquid applied coating specifically for use in water and wastewater applications including those which require ANSI/NSF 61 potable water certification. Typical applications for this two component elastomeric urethane coating include tank and reservoir liners, joint seals, tank repairs, and chemical containment.
Other characteristics
- Brand
- CIM
- Features
Abrasion Resistant, Chemical Resistant, Good Toughness, Good UV Stability, Wear Resistant
- Product Type
- 2K (2 component) Coating, Elastomeric Coating
- Application Area
- Tanks
- Application Method
- Roller, Trowel
- Compatible Substrates & Surfaces
- Concrete, Glass, Metal, Steel, Wood
- Mixing
DO NOT THIN. DO NOT HAND MIX. Begin mixing each pail (4.4 gal.) of CIM 1061 Premix using a pOwer mixer (e.g. 2 drill and an eight inch mud mixer). Do not draw air into the mix. While mixing, slowly add one jug (0.6 gal.) of CIM 1061 Activator to the pail and mix thoroughly for 3 full minutes. The proportions are premeasured; DO NOT ESTIMATE. Mixing Jigs and Timers from C.I.M. Industries help eliminate mixing errors and increase productivity on the job.
- Markets
- Paints & Coatings
- Pot Life
About 30 minutes. Working time depends on temperature and method of application. Working time for spray applications will be significantly shorter.
- PACKAGING
CIM 1061 is available in mixed units of O.8 gallons and 5 gallons. Each unit consists of a container of premix and a smaller container of activator. Quantities have been premeasured to provide the proper mixing ratio, leaving sufficient room in the premix container to facilitate adequate mixing. Do not estimate proportions.
Technical data
Table 1 of 1
30 rows| Characteristic | Value | Unit | Method |
|---|---|---|---|
| Solids by Volume (1416 dry mils x sq. ft./gal.) | 88.0 | % | — |
| VOC | 90 (0.75) | g/l (lb./gal.) | — |
| Abrasion Resistance (Loss) | 1.2 | mg | ASTM D4060 CS-17 Wheel, 1000 rev |
| Adhesion to Concrete (Dry) | 350.0 | psi | Elcometer |
| Deflection Temperature (Minimum Use Temperature) | max. -60 | ºF | ASTM D648 |
| Density Premix | 8.0 | Ibs./gal. | — |
| Density Activator | 10.1 | Ibs./gal. | — |
| Density Mixed & Cured | 8.3 | Ibs./gal. | — |
| Elastomeric Waterproofing | Exceeds all criteria | — | ASTM C836 |
| Elastomeric Waterproofing | Exceeds all criteria | — | ASTM C957 |
| Extension to Break | 300.0 | % | ASTM D412 |
| Flooring and Shower Lining | Pass | — | UPC/IBC ANSI 118.10 |
