Heresite Protective Coatings LLC UC-5500
UC-5500 is formulated as a top coat for other Heresite Coatings. It exhibits outstanding UV resistance with excellent weathering qualities, along with good flexibility and good abrasion resistance. This two component coating is typically sprayed on the exterior surfaces of heat exchangers and related equipment, process equipment, transport vessels, tanks and structural steel
Identification
Product families
- Industrial Coatings
Other characteristics
- Features
Abrasion Resistant, Exceptional UV Resistance, Good Weather Stability, High Flexibility, High Performance, High Solids Content, Higher Gloss, Improved Adhesion
- Product Type
2K (2 component) Coating, Solventless & High Solids Coating, Top Coat; 2K (2 component) Coating; Solventless & High Solids Coating; Top Coat
- Application Area
- Heat Exchangers
- Application Method
- Spray
- Compatible Substrates & Surfaces
- Metal
- Avoid
Water under high pressure, such as a high-pressure washer. Fins may fold under high pressure causing the coating to crack; Abrasive products or processes to scour or remove dirt; Striking the coil with a tool to dislodge or remove soil or residue; Corrosive, caustic or alkaline cleaners (with a pH 5.5 - 8.5) as these may permanently damage the coating and void the warranty
- Caution
Contains flammable solvents. Keep away from sparks and open Flames. In confined areas workers must wear fresh air line Respirators. Persons should wear gloves or use protective cream. All Electrical equipment and installations should be made and grounded In accordance with the national electrical code. In areas where Explosion hazards exist, workmers should be required to use Nonferrous tools and to wear conductive and nonsparking shoes.
- Markets
- Paints & Coatings
- Coverage
Theoretical coverage is 994 square feet per gallon per dry mil. Coverage rates are estimates and make no allowance for material loss. Actual rates will vary dependent on application method, surfaces, etc.
- Thinning
If applying via HVLP or conventional spray equipment, thinning may be required. A maximum of 20 fl. ounces of S-550 per gallon of combined Part A and Part B may be used. Do not exceed this recommendation otherwise performance and cure can be impacted. VOC will be impacted with the addition of S-550.
- PACKAGING
UC-5500 series is available in one-gallon kits. Both Part A and Part B are provided in short-filled cans, allowing for accurate and easy mixing.
- Cure
- Air Dry
- Technology
- Ready-to-Use Products
- Packaging Type
- Cans
- Cleaning Process
Turn off electrical power to the unit using lock-out system; Flush the coil with water to rinse off loose residue. Allow the water to soak for 10–20 minutes to loosen surface residue; Flush the coil thoroughly with any mild liquid detergent and warm water (~100°F) until all signs of residue are eliminated. If harsher cleaners are required for your environment, please contact Heresite for advice; Rinse the unit thoroughly with clean water (it should not be brackish or contain excessive dissolved minerals); Allow the unit to dry completely prior to turning the electrical power on or returning the unit to service.
