BURN BARRIER™ No. 400
- Chemical Family
- Acrylics & Acrylates
BURN BARRIER No. 400 Semi-gloss Acrylic is a Class “A” rated, water base, general purpose, fire resistant paint, designed for use on all interior and exterior surfaces, except floors, where maximum durability coupled with fire resistancy is required. No. 400 may be utilized as an overcoat on most intumescent type fire retardant coatings to improve their cleansibility, scrubbability, and overall durability.
Product families
- Protective Coatings
Other characteristics
- Brand
- BURN BARRIER
- Features
Flame Resistant, General Purpose, High Durability
- Product Type
- Waterborne Coating
- Application Method
- Brush, Roller, Spray
- Carrier
- Water
- Caution
- Do not take internally
- Keep out of reach of children
- Tinting
Available in white, off white, and colors or may be field tinted with most universal tinting colorants.
- Handling
- Close container after each use
- Protect from freezing
- Thinning
For thinning, use only water [maximum ½ pint per gallon]. For equipment clean up, use warm soapy water.
- PACKAGING
- 1 gallon Container
- 5 gallon Container
- 55 gallon containera
- Application
BURN Barrier No. 400 is ready to use. It can be applied by brush, roller, airless or conventional spray equipment. Stir thoroughly and apply, using a full-bodied coat. If thinning is required, use water only, do not exceed ½ pint per gallon. Do not apply when surface or air temperatures are below 50°F.
- Drying Time
Dries to touch in approximately 30 minutes, can be recoated in 1 to 2 hours.
- Technology
- Ready-to-Use Products
- Application Methods
- Brush
- Roller
- Spray
- Surface Preparation
Surface preparation should be carried out according to good painting practices. Remove all loose, peeling or powdery paint from the surface. All dirt, grease, oil, wax, and other foreign matter MUST be removed with a detergent. Rinse surfaces thoroughly with clear water and allow to dry. Repair all cracks, holes, and other surface irregularities. Allow to dry, sand lightly and prime repaired surfaces with No. 400.
- Coverage Rates
300 to 420 sq.ft./U.S. gallon [7.4 to 10.3 m2/L depending on substrate.
- Ready to Use Product Features
- Flame Resistant
- General Purpose
- High Durability
- New and Previously Painted Surfaces
BURN Barrier No. 400 can be applied directly to most surfaces. Metal surfaces must be primed with a good quality metal primer. On combustible surfaces where maximum fire protection is required, a coat of BURN Barrier intumescent fire retardant paint should be applied before the application of Flame Control No. 400.
