Anti-Hydro® -R 1-1A
Anti-Hydro ® -R 1-1A is widely used for integrally waterproofing concrete and mass concreting. It has been used successfully in all types of structures since 1904 to waterproof concrete and improve its workability, strength, hardness, and durability. Foundations, elevator pits, sewage and water treatment plants, seawall construction, tunnels, tanks, tilt-ups, pavements, slabs-on-grade, exposed concrete, underground utility constructions, and so on are examples of installations.
Product families
- Concrete Admixtures
Other characteristics
- Brand
- Anti-Hydro
- Features
Easier Processing, High Durability, High Hardness, High Strength
- Product Type
- Concrete Admixture
- Application Area
- Tanks
- Safety
Use approved safety goggles, rubber gloves, coveralls and work boots. Protect animals, vegetation and food items.
- Markets
- Building & Construction
- Industrial
- Storage
Store in a dry, cool place. Keep containers tightly closed. KEEP AWAY FROM CHILOREN.
- PACKAGING
'A-quart, 1-gallon, 5-gallon, 55-gallon or 220-gallon containers, ESTIMATOR'S DATA GUIDE: 1% gallons of "Anti-Hydro®" per cubic yard of concrete. 1 gallon of "Anti-Hydro" per 150 sq. ft. of Slush Coat,
- Maintenance
All due diligence must be exercised to provide a regular and frequent maintenance plan to clean and'protect finished surface from severe or prolonged assault Irom»chemical attack, abrasive atttack Similiar abuse.
- Precaution
Installation No concrete shall be placed on wet or soggy ground without first laying and compacting a bed of broken stone or gravel of adequate thickness to prevent the mud from mixing with the concrete, A pump of sufficient capacity to keep water below the poured concrete shall be operated continuously during the placement and for at least 24 hours thereafter. The excavated area must be so prepared that the water will easily drain to the pump without washing cement out of te newly placed concrete. If saw cutting is required, then apply as soon 8 work is completea, ana wnen the area is clean and dry, apply masking tape over all saw cuts to keep dirt and debris out. Wait 28 days for sufficient vapor reduction and fill all saw cuts with eitherRefer to ACI 402-9.10. ""Anti-Hydro" conforms to the requirements of ACI 318-4.4.1 and ACI 318-3.6.3. "Ani-Hyowo™, when tested following ASTM C 876-91, exhibited no corrosion. However, Do NOT use "Anti Hydro™ in pre-stress or posttension applications or where chlorides are not acceptable. Testing for set time is recommended before use as a result of recent globalization of cement sources. For ambient and substrate temperatures in excess of 80°F, use In place of "Anti-Hydro™ Where job specifications reauire. Water Pressure In dealing with any structure subject to hydrostatic pressure, careful consideration must be given to the design of the members. Thickness and reinforcing must be capable of withstanding maximum potential heads, Possible flotation should be checked, Curing Under Adverse Conditions concrete slabs are to be placed at temperatures over 80°F, in the direct rays of the sun, or exposed to drying winds, care should be taken to prevent water loss. Dampen sub-base, erect wind barriers, finish concrete nramotly, and start curing, immediately by the use of water Curing, of sheet materials. Continue curing for a minimum of 7 days. 7 days.
- Technology
- Ready-to-Use Products
