Chempart® SC-100
- CASE Ingredients Functions
- Binder & ResinDefoamer
- Chemical Family
- Polysaccharides
Chempart® SC-100 is Polysaccharide Resin that uniquely processed film forming resin. It is a coactive resin which will form a hydrogen bond with alkyd and stabilize water molecules with the enamel coating. Surrounds the dispersed water droplets impeding their attraction with each other, promoting steric stabilization of the water-in-oil emulsion. During water evaporation (Chempart SC100) prevents voids and pinholes from forming in the film, and works to maintain the film's durability and performance.
Product families
Applications
- Paints & Coatings — Other Paints & Coatings Applications
- Other Automotive & Transportation Coatings
- Architectural Coatings
- Roof Coatings
- Architectural Coatings
- Other Coatings & Finishes
Product Families
- Foam Control
- Other Resins & Binders
Other characteristics
- Brand
- Chempart
- Functions
- Binder & Resin, Defoamer
- Labeling Claims
- Environmentally Friendly
- Markets
- Automotive & Transportation
- Building & Construction
- Paints & Coatings
- Coating Type
- Enamel
- Solventborne Coating
- Technology
- CASE Ingredients
- HIGHLIGHTS
It's a new environmental-friendly technology to produce enamel paints which meet VOC requirement in REACH 2010; It's a system of incorporating water into enamel paints up to 35% in a process called Alkyd Emulsifica-; This system can reduce the total cost of enamel paints up to 20%; It's a blend of experience and knowledge designed to meet the market needs; The final product is still solvent base as it diluted with aliphatic and aromatic solvents; Chemical Partners experts can help you in formulating and implementing the technology to give you the maximum benefits in cost savings and performance.
- Certifications and Compliance
- REACH (Europe)
- Guide Formula
Required definite mixer speed < 20 M/S (1500-2000 rpm).; Definite rate of water addition (60-100 L/M).; Mixing time for 35 min.; Stability Tests; Heat Stability Test The test done by putting sample of Emulsion Intermediate in the oven at 60 C for 48h. Check the sample, if there's any syneresis or not, if not the sample is OK; The test done by putting sample of Emulsion Intermediate in the oven at 60 C for 48h.; Check the sample, if there's any syneresis or not, if not the sample is OK; Viscosity Test Viscosity measured by KU at 25°C must be in the range of 90-95 KU Measured by stormer or equivalent method; Viscosity measured by KU at 25°C must be in the range of 90-95 KU; Measured by stormer or equivalent method; The Formula of white enamel as the following:; Gloss:90.600; Density:0.989/1; Viscosity:480CP; Drying time:; Touch 1.5h Through Drying 3h
