Helena Agri-Enterprises Fire-Zone (HAE)
Helena Agri-Enterprises Fire-Zone (HAE) is a highly effective blend of methylated seed oils (MSO) and surfactants, designed exclusively for burn-down, desiccation and industrial weed control applications. It provides a faster weed killing response and works well in adverse weather conditions. It should not be used in over-the-top weed control applications in a growing crop.
Properties
- Physical Form
- Liquid
Product families
- Industrial Weed & Vegetation Control
Other characteristics
- Functions
Drift Control Agent, Herbicide, Sticker, Surfactant
- Application Technique
- Aerial Application, Ground Soil Applied
- Markets
- Agriculture & Feed
- Technology
- Agrochemicals
- Packaging Type
- Cases
- Formulation Type
- Concentrate Solutions
- Use Direction
NOT FOR AQUATIC USE FOR USE WITH PRODUCTS REGISTERED FOR: AGRICULTURAL, FORESTRY, INDUSTRIAL, MUNICIPAL, NON-CROPLAND, RIGHTS-OF-WAY, AND OTHER USES.; Prior to the addition of FIRE-ZONE® to spray tank mixes or prior to the use of FIRE-ZONE® with a herbicide or fertilizer where an oil concentrate adjuvant is not specifically recommended but not prohibited by the manufacturer, the user or application advisor must have experience with the combination or must have conducted a phytotoxicity trial.; FIRE-ZONE® may be applied by Ground, CDA, or Aerial equipment. In most applications, use enough FIRE-ZONE® to allow for uniform wetting and deposition of the spray onto plant surfaces without undue runoff. Typical use rates are 1.0% by volume (1 gallon per 100 gallons of spray) or 1 pint per acre.; NOTE: The above use recommendations are considered to be adequate for most uses. Some herbicides, however, may require higher or lower rates for optimum effect. Follow the pesticide label directions when this occurs.; NOTE: Do not mix with oxidizing agents unless oxidizing agents are in solution. For Basal Bark Applications: This product can be mixed with oil soluble or miscible herbicides and, when allowed by the herbicide label, be used as the sole diluent or carrier. Thinline, streamline, high and low volume basal bark applications can be made with this product and labeled herbicide mixtures. Suggested mixing rates when used as the sole carrier vary from 1% herbicide in 99% of this product to 75% herbicide in 25% of this product depending on herbicide and method of application. For specific dilution rates consult the herbicide label for the product being used.; For directed or broadcast stem and foliage spraying: When allowed by the herbicide label, this product can be used as the sole carrier for herbicides or used with herbicide/water mixtures. For herbicide and water mixtures use up to 40% of this product by volume in these mixtures. Consult the herbicide label being used for proper mixing sequences. Maintain agitation at all times to prevent separation. When used as the sole carrier with oil soluble herbicides add the required amount of herbicide to this product in the spray tank. Consult the herbicide label of the product being used for use rate and volume per acre recommendations. If the compatibility of mix components is unknown, conduct a jar test before mixing large quantities. Use coarse sprays or special equipment designed to minimize spray drift.; NOTE: Observe precautions on labels of other products regarding potentially phytotoxic interactions with oils.
